narex CHJ XS-XXL SET Bunda SOFTSHELL Battery Heating User Manual

narex CHJ XS-XXL SET Bunda SOFTSHELL Battery Heating

Symbols Used in the Manual and on the Product

Figure and description of pictograms

1. Can be washed in a washing machine on a gentle wash cycle with warm water
2. Can be dried at low temperatures
3. Do not bleach!
4. Do not iron!
5. Do not clean chemically
6. Do not wring!!
7. Not suitable for young children! (0–3 years of age)
8. Do not puncture the fabric!
9. Does not belong among municipal waste!

Safety Warnings

Read all safety warnings and instructions!
Failing to follow the safety warnings and instructions may result in fire, injury by electric current and/or serious injuries.

Keep the safety warnings and instructions safe for future use.

• The heated jacket must not be used by children younger than three years of age, persons dependent on others, persons insensitive to heat or persons with poor blood circulation. Children older than three years of age may use the jacket only once a parent or other custodian makes the necessary settings or sufficiently explains how to use it safely.
• If you find that wearing the product causes some of the symptoms below, immediately take it off and consult a doctor. Otherwise, there is a risk of exhaustion from heat or heatstroke.

Initial symptoms:

• any feeling of weakness; excessive sweating; pain at the back of the neck; nausea; dizziness or faintness
  Symptoms of exhaustion from heat/heatstroke:

• nausea and vomiting; throbbing headache; dizziness and faintness; anhidrosis (absence of sweat); red, hot, and dry skin; muscle weakness or cramps; palpitations; fast, shallow breathing; changes in behavior, e.g. confusion, disorientation or staggering walk; loss of consciousness

• To prevent heatstroke, turn off the heating when you enter a noticeably warmer environment.

• Do not wear during pregnancy.

• Do not wear if you suffer from problems resulting in sensitivity to overheating, or if you have a medical device implanted. Ask your doctor and/or the manufacturer of the medical device whether you can wear this heated piece of clothing.

• Never wear the heated jacket when the lining is wet.

• The heaters should not come into contact with bare skin.

• Do not use the cable with the connector for other purposes, e.g. carrying the jacket, pulling at the jacket or removing the power bank from the pocket. The cable must not come in the vicinity of oil, sharp objects or moving parts. Do not sharply bend the cable. A faulty heater or cable with a connector may cause the jacket to malfunction and increases the risk of fire or injury by electric current.

• The heated jacket is not suitable for medical use, e.g. in hospitals.

• If you find that the jacket has been used improperly, do not use the jacket and send it in for servicing to Narex s.r.o.

• Handle all labels and name tags with care. They include important information. If the information is no longer legible or is missing, contact a service center of Narex s.r.o.

• If the clothes are hot, do not fold them or place any objects on them. A faulty heater or cable with a connector may cause the jacket to malfunction and increases the risk of fire or injury by electric current.

• Let the jacket cool down before you store it.

• Regularly check the jacket for wear and tear or damage. If the jacket shows signs of wear or damage, improper use or malfunction, do not use the jacket.

• Minor stains or dirt may be cleaned with a moistened cloth

Product Description

1. Switch and temperature regulator
2. Heaters
3. Inside pocket with connector for power bank
4. USB connector
5. Textile case of the controller
6. USB connector cover
7. PWB 10 power bank

Some accessories displayed or described here may not be included in the delivery.

Technical Information

Weight based on size:
XS| 1.28 kg
S| 1.32 kg
M| 1.35 kg
L| 1.41 kg
XL| 1.49 kg
XXL| 1.53 kg
Recommended power bank| PWB 10
Power bank:
Type| PWB 10
USB interface| USB 2.0
Input:
Micro USB| 5.0 V / 2.0 A
USB‑C| 5.0 V / 2.0 A
Output:
USB 1| 5.0 V / 1.0 A
USB 2| 5.0 V / 2.0 A
Capacity| 10,000 mAh
Li‑Ion cells| 3.7 V / 37 Wh
Charge time| 4–5 hod.
Weight| 185 g
Recommended ambient temperature
Charging/storage| 0–45 °C
Operation| ‑20 – +50 °C

Using the Product

1. Connect the power bank  [7] to the input USB connector  [4] located in the inside pocket [3] on the left side of the jacket.
2. To turn on the heating, first, remove the controller’s textile case [5] fitted with a hook‑and‑loop fastener and press the on switch [1]. The LED of the switch will start flashing red until the heaters [2] reach the maximum permitted operating temperature (ca. 5 minutes). Once the maximum operating temperature has been reached, the heating automatically switches to a medium setting. The LED of the switch will start glowing blue. After that, pressing the switch [1] allows you to select between different heating modes.
3. The heating mode of choice can also be selected immediately after activation. Once a heating mode has been selected, the heaters will warm up to the temperature listed in the table.
4. Once you have set the heating mode, replace the controller’s textile case [5] using the hook‑and‑loop fastener.
   Heating mode settings:
   (Heating mode is indicated by the colour of the LED of the switch [1])

5. To turn off the heating, hold the switch [1]

Runtime:
(Runtime is dependent on the type of the power bank and the selected heating mode!)

• When using the power bank Narex PWB 10: 5 V / 2.1 A output
• When using the power bank Narex PWB 10: 5 V / 1.0 A output

Warning!
Do not use a power bank with a voltage higher than 5  V! Power banks with a voltage over 5 V are not designed for this type of heating!

Do not open the power bank. Store it in a dry place and protect it against humidity. The power bank may leak fluid when under extreme load or at high temperatures. Immediately wash any areas of the body that came into contact with the liquid with water and soap. In case of contact with eyes, immediately rinse the eye thoroughly for at least 10 minutes and seek medical attention without delay.

Maintenance and Service

Before you do any work on the clothes (e.g. washing), remove the power bank [7] from the inside pocket and disconnect it. Take the USB connector cover [6] connected to the power cable and fit it onto the input USB connector  [4]. Empty all the pockets before washing the jacket. The jacket can be washed with a USB connector [4]. Follow the symbols for washing the jacket.

Attention!
In case of any malfunction of the jacket’s heating, contact an authorised service center.

You can find an up‑to‑date list of authorised service centers on our website at www.narex.cz.

Environmental protection

Do not dispose of power tools into household waste!
Power tools, accessories and packaging should be sorted for envi‑ ronmental‑friendly recy.

Only for EU countries:
According to the European Directive 2002/96/EC on waste electrical and electronic equipment and its incorporation into national law, power tools that are no longer suitable must be separately collected and sent for recovery in an environmental‑friendly manner.

Warranty

Our equipment is under warranty for at least 12 months with regard to material or production faults in accordance with national legislation. In the EU countries, the warranty period for exclusively private use is 24 months (an invoice or delivery note is required as proof of purchase). Damage resulting from, in particular, normal wear and tear, over-loading, improper handling, or caused by the user or other damage caused by not following the operating instructions, or any fault acknowledged at the time of purchase, is not covered by the warranty.

Complaints will only be acknowledged if the equipment has not been dismantled before being sent back to the suppliers or to an authorised NAREX customer support workshop. Store the operating instructions, safety notes, spare parts list, and proof of purchase in a  safe place. In addition, the manufacturer’s current warranty conditions apply.

Note
Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation.

Certificate of Conformity

CHJ XS–XXL:
We declare that the device meets the requirements of the following standards and directives.

Safety

• EN 60335‑1
• EN 60335‑2‑17
• Directive 2014/35/EU

RoHS

• Directive 2011/65/EU
• Place of storage of the technical documentation:
• Narex s.r.o., Chelčického 1932, 470 01 Česká Lípa, Czech Republic

Narex s.r.o.
Chelčického 1932 470 01 Česká Lípa

Jaroslav Hybner CEO of the company
December 3, 2021

Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Czech Republic
Tel.: +420 481 645 471–2; +420 481 645 227
Fax.: +420 487 823 207
E-mail: narex@narex.cz
www.narex.cz.

References

• Narex Česká Lípa | výrobce elektronářadí

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>