netool io L3 Allin1 Router User Manual
- June 3, 2024
- netool io
Table of Contents
netool io L3 Allin1 Router
Product ID
Product spec
- Material: ABS plastic material
- Input: 5V1A
- Battery capacity: 2500mAh
WiFi Functions
Internet connection
- plug in the cable for internet connection
- Press the”power button”to turn on the WIFI , searching WIFI name: mt76285152, password:12345678;the LED of “ Ethernet status” flashes slowly means WIFI connected successfully.
USB C Data port
Open IP address in browser:192.168.1.1,key in user name:root,password:198277, connect with type-c U disk, go to system and choose “mount points”, will read U Disk ROM 16M/RAM:32M, then means it works 。
Reset setting
Use one pin to press the “Reset” button for 3~4 seconds ( blue light flashes quickly on the power button for seconds , then it is done)
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>