Dsenbor T585-F Magnetic Wireless Charging Stand User Manual
- June 4, 2024
- Dsenbor
Table of Contents
Dsenbor T585-F Magnetic
Wireless Charging Stand
User Manual
Model: T585-F
How to Use
- Connect to a power adapter.
- Attach your iPhone 12/13 to the top magnetic pad, and place your Charge your phone, Apple Watch, or AirPods.
(The wireless charging pad below are for AirPods only)
Attention
-
Do not disassemble the device.
-
Please make sure your device is Qi-compatible or has a Qi receiver kit (not included).
-
Your phone should be MagSafe compatible or equipped with a magnetic plate or phone case in order to achieve the magnetic charging effect. (such as a magnetic protective case).
-
A Quick Charger adapter and cable are required for the fast wireless charging features. (Power adapter is sold separately)
-
Do not use or store the magnetic wireless charger in a hot or humid environment as it may damage the circuit.
-
A magnet may interfere with the magnetic charging of the product or cause malfunctions; To avoid interference between other devices and products, please keep magnetic chip cards (such as ID cards, credit cards) or medical devices (such as pacemakers, defibrillators, hearing aids, etc.) away from the product. Keep a distance of at least 20 cm from the product, and more than 30 cm during wireless charging.
-
LED Indicator Status
- Power on — Both indicators flash 3 times quickly and then go out.
- Standby mode Both indicators go out.
- Charging 1 device — Both indicators are on simultaneously. Charging 2 devices — Both indicators are on simultaneously.
- Charging 1 devices but paused due to a foreign object detected — Both indicators flash.
- One device was charging, and the other paused due to a foreign object detected. (Please remove: the object o continue charging.) — One light is on the other light flashes.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum distance between 20cm between the radiator and your body: Use only the supplied antenna.
Warranty
Garantie
24-Month Warranty
Lifetime Technical Support