HUNTER 73027-WH Personal Ceramic Heater Instruction Guide

HUNTER 73027-WH Personal Ceramic Heater

The 750-Watt Hunter Wall Mount Space Heater with Remote Control can add warmth and comfort to any room. For home offices and tiny places, this heater’s modest, compact size is ideal. Your room will stay at the temperature you desire thanks to the thermostat’s customizable features, digital display, and two heat settings. Even better, it has a remote control so you can change the temperature from 59 to 86 degrees while lounging in your chair. Finally, benefit from our overheat prevention with its 60-second cool down function, cool touch housing, grill, and grill. As always, Hunter creates heaters that make your house more comfortable and convenient.

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons or property, including the following:

1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Be extremely cautious when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3′ (0.9 m) from the front and top of the heater and keep them away from the sides.
3. Extreme caution is necessary when any heater is used by or near children, and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate heater with a damaged plug, or if the heater has been dropped or damaged in any manner. Discard heater or return to an authorized service facility for examination and/or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never place heater where it may fall into a bathtub or other water container.
8. Do not cover heater with throw rugs, runners, or similar coverings.
9. To disconnect the heater, turn control to OFF, then remove the unit from the outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire or damage to the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored.
13. Use heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, injury to persons, or other damage to property.
14. Ensure heater is plugged into a socket on a vertical wall when use, keep at least 8″ of unobstructed space to the bottom air inlet of the heater to allow for ventilation to avoid a risk of danger.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into the same outlet or into another outlet wired into the same circuit.
16. It is normal for the heater’ plug to feel warm to the touch. A plug which becomes hot to the touch or becomes distorted in shape may be a result of a worn electrical outlet. Worn outlets or receptacles should be replaced prior to further use of the heater. Plugging heater into a worn outlet/receptacle may result in overheating or fire.
17. Always plug heaters directly into a wall outlet. Never use with an extension cord or relocatable power tap (outlet/power strip).
18. Check the heater plug connections. A loose-fitting outlet can cause the plug to overheat or cause a fire. Be sure plug fits tight in the outlet. Check frequently during use to make sure plug and outlet are not hot. If so, discontinue using heater and have the outlet replaced by a qualified electrician.
19. Note: Heaters draw more current than small appliances, overheating of the outlet may occur even if it has not occurred with the other appliances.
20. Do not use cord extension sets, multiple socket outlets or adaptors to avoid a risk of danger. Plug only into a wall socket outlet.
21. Make sure no pieces of polystyrene or other packaging material have been left between elements of the appliance. It may be necessary to clean the appliance.
22. Never leave heater on while sleeping.

Danger-high temperatures may be generated under certain abnormal condition. Do not partially or fully cover or obstruct the front of this heater.

GROUNDING INSTRUCTIONS

This appliance is for household use only and may be plugged into any 120-volt AC electrical outlet (ordinary household current).

DO NOT use any other type of outlet.

WARNING: This unit is suitable for grounded receptacle use only.

This unit has a grounded plug as shown in Figure 1. An adapter, as shown in Figure 2, is available for connecting three-blade grounding-type plugs to two- slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a property grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.

NOTE: The adapters ARE NOT supplied with this heater. Read, follow, and save the instructions that are included with the adapter you choose.

GROUNDING PLUG SAFETY TIPS

1. NEVER pull or yank on the plug or the appliance.
2. To insert plug, grasp the heater firmly and guide it into the outlet.
3. To disconnect the appliance, grasp the heater and remove it from the outlet.
4. Before each use, inspect the grounding plug for cuts and/or abrasion marks. If any are found, the appliance should be serviced. Please return it to our Service Department or to an authorized service representative.
5. DO NOT operate appliance if the grounding plug shows any damage, if the appliance works intermittently or stops working entirely.

PARTS OF THE HEATER

1. Control Panel
2. LED Display
3. Safety Grille
4. On/Off Switch
5. Remote Control

SYMBOLS

• Power Button
• (+) Plus Button
• (-) Minus Button
• Timer Button

OPERATION INSTRUCTIONS

OPERATION

1. Check there is no damage to the plug-in heater.
2. Plug the plug-in heater into a 120 volts AC outlet. Be sure the plug fits tightly into outlet. When plugs fit loosely into receptacles, they may slip partially or completely out of the receptable with only the slight movement of the unit. Receptables in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape, the fire hazard is even greater.
3. To give power to the plug-in heater, press the on/off switch to the ‘on’ (I) position, the LED display will turn on indicating power to the unit. The LED display will remain lit until the on/off switch is pressed to the ‘off ‘(O) position.
4. Turn the heater ON by pressing the Power Button .
5. To turn the heater OFF, press the Power Button The unit will first turn off the heating elements, the fan will shut down 60 seconds later. Press the on/off switch, on the side, to completely power off the unit. Unplug the unit by pulling the plug from the electrical outlet only after the fan has stopped and the unit has cooled down.

TIMER FUNCTION

The timer function may be activated when the heater display is in any function. This function allows you to set the length of time, from 0 hour to 12 hours, the heater will run before turning itself off.

Pressing the Timer Button  will increase the length of time by 1 hour each time the button is pressed. After the display reflects 12 hours, pressing the Timer Button  once more will reset the heater to run continuously. The heater will turn off when the set time has elapsed. The unit can be turned back on by pressing the Power Button . Pressing the Timer Button  to 0 hour will cancel the timer function.

AUTOMATIC TEMPERATURE CONTROL

1. To set the room at a specific temperature, press the + or – buttons.

NOTE: The temperature display does not indicate the temperature of the heated air being emitted by the heater. The heater can only indicate the temperature you have set at point 1 above and may not reflect the actual room temperature.

2. Once the room temperature reaches 2 degrees above the set temperature, the heater will shut off. Once the room temperature reaches 2 degrees below the set temperature, the heater will turn back on and continue to cycle off and on to maintain the set temperature.

NOTE: It is normal for the heater “fan” to run for approximately 60 seconds when the heater shuts off after reaching the set temperature.

You also can press the or buttons on the remote control to set the room at the desired temperature.

ROTATING THE PLUG

WARNING: Only attempt to rotate the plug when the plug-in heater is cool and unplugged.

1. Press and hold the plug rotation button on the back of the plug-in heater.
2. Rotate the plug 180° whilst holding the plug rotation button.

REMOTE CONTROL

1. The remote control uses one (1) “CR2025” button cell (included) for operation.
2. All functions performed by using the remote-control work identically on the unit. To change the heat setting from high (HH) to low (LL) without the remote control button, press the (+) and the (-) buttons on the unit at the same time. To change the heat setting back to high heat (HH), repeat the same function.
3. Replace the battery if the remote control does not operate well.

NOTE: Remove the battery out of the remote control if you won’t use the remote control for a long time. To install or replace the button cell, simply press the holder at the bottom of the handheld remote-control unit with your thumb to pull out the battery cover. Replace with a new “CR2025” button cell, and then replace the cover.

Battery Disposal – Please dispose of the used battery per municipal or provincial law.

WARNING

1. Keep batteries out of reach of children. Should a child swallow a battery, consult a doctor immediately.
2. Do not recharge or dispose in fire.
3. Keep in a dry and cool place.
4. Insert battery in correct direction.

THERMAL CUT-OFF PROTECTION SYSTEM

This heater includes an Overheat Protection System that shuts the unit off permanently when a potential overheat temperature is reached. If this occurs, the heater can only resume its normal operation after resetting it. To reset the heater:

1. Press the Power Button to turn the heater OFF and press the on/off switch to the “off” (O) position.
2. Unplug the heater and wait 10 minutes for the unit to cool down.
3. After the 10 minutes, plug the unit in again and operate normally.

CLEANING AND MAINTENANCE

1. Press the Power Button to turn the heater OFF and press the on/off switch on the side to the ‘off ‘ (O) position. Allow the unit to cool down and unplug the heater before moving or cleaning.
2. Interior dust can often be removed by using a vacuum cleaner with a crevice tool attachment.
3. To clean the enclosure, use a clean, soft and lightly damp cloth to gently wipe off the dirt from the surface of the unit. Be sure not to wet the heating element and switches. Allow the unit to dry completely before use.
4. Do not use cleaning liquid or other chemicals to spray on the unit.

WARNING: Any other servicing should be performed by an authorized service representative.

STORAGE

1. Perform the cleaning procedures described above.
2. Wipe all parts dry.
3. Pack the heater in a plastic bag and store it in a cool, dry place. We recommend storing the heater in its original carton.

TROUBLESHOOTING

IF YOUR HEATER FAILS TO OPERATE:

• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction, turn the heater OFF, and UNPLUG THE UNIT. Carefully remove the obstruction and follow the reset instructions.

FAQs

What is the lowest temperature and highest temperature setting possible?****

The Hunter 750W Wall Mount Space Heater can go from 59°-86° degrees.

I have two questions. Is it quiet and does it glow? Plan to use in our camper bedroom.****

The 750W Wall Mount Space Heater is a quiet heater; however, does not glow in the dark.

Does the face of the heater get hot? I know the housing is supposed to stay cool to touch, but I am looking for something that I can use with my kid****

The grill does get hot while heater is operating; however, once power button is turned off heater becomes cool to touch.

Can I use this with an extension cord?****

The 750W Wall Mount Space Heater with Remote Control cannot be used with an extension cord.

Does the front mesh get hot or is it cool touch?****

The 750W Wall Mount Space Heater with Remote Control becomes cool to touch once heater is powered off.

Does the prongs rotate? One product image shows the third (grounding) prong on the bottom while the 360 view shows it at the top.****

Yes, the plug-in prong is capable of 360 rotation. There is a push in button located next to the plug-in prong, that you press and hold to rotate the prong.

According to the user manual the plug can be rotated. Has anyone used this heater in this position with the controls down. Does it affect heating?****

The rotating plug in does not affect heating. Please contact our customer support team at 888-880-3267 if further assistance is needed.

Was any TEFLON, nonstick coating, PTFE or PFOA used in making this?****

Teflon, nonstick coating, PTFE or PFOA is not used in making the Hunter 750W Wall Mount Space Heater.

Does it resume heating after a power failure?****

The Hunter 750W Wall Mount Space Heater does not resume power after a power outage. You will have to press the on/off switch before pressing the power on/off button.

Can I use the heat without the timer?****

The 750W Wall Mount Space Heater can be used without activating the timer.

Is the remote RF or IR (line of sight)?****

The remote for the 750W Wall Mount Space Heater is IR.

Is it normal for the heater to labor to turn the fan slowly before picking up speed and putting out heat?****

That doesn’t sound normal. My fan starts out full blast while heating up at the same time.

Why can it not be used in a bathroom or laundry room?****

The Hunter 750W Wall Mount Space Heater cannot be used in rooms of high moisture.

Most of my walls have outlets at floor level. Will this work at that low level? Can I plug it into an extension cord to hang on wall?****

Personally, I would not feel comfortable plugging into an extension cord and hanging. I do have this heater plugged into a receptacle that is about 2’ from the ground. Also have one in our master bath. Warms a cool bathroom within a few minutes quickly.

Can it be used in a small bathroom?****

The 750W Wall Mount Space Heater cannot be used in a small bathroom.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>