CELESTRON 93607 Heavy Duty Alt Azimuth Tripod User Guide
- June 3, 2024
- Celestron
Table of Contents
CELESTRON 93607 Heavy Duty Alt Azimuth Tripod
Overview
- A. Mounting bolt
- B. Mounting head and position controls
- C. D-shaped gear shaft
- D. Slow motion control dials
- E. Azimuth control tension dial
- F. Eyepiece accessory tray
- G. Leg position locks
- H. Spiked feet
Unpack your tripod and verify that all parts are present. Your Heavy-Duty Alt-
Azimuth Tripod includes: the tripod with alt-azimuth adjustable head, two
azimuth slow motion control dials, an azimuth control tension dial, and an
eyepiece accessory tray.
To set up the tripod, spread the legs outward until they are fully extended
and push down the center leg brace.
Extend the center portion of each of the three tripod legs down about 6 to 12
inches. Use the tightening screw on each leg to secure the extended leg in
place.
Check to ensure that all three legs are the same height once extended to
provide a level platform for the telescope.
Place the eyepiece accessory tray on top of the tripod’s center leg brace.
Thread the tray into the threaded hole in the center of the leg brace until it
is fully seated.
NOTE: If necessary, rotate the accessory tray counterclockwise until the
accessory holes are not covered by the leg brace arms as shown
here.
Attach the slow motion control dials to your mount, Although these have two
different length arms, it is your preference which to attach to which control
point.
Place the slow motion control dials over the D-shaped gear shaft and push inward to make sure they are fully seated. Use your fi ngers to tighten the setscrews onto the gear shaft. Further tighten the setscrew using a fl at blade screwdriver if desired.
Attach the azimuth control tension dial.
Attach your telescope, spotting scope, or binocular tripod mount to the mounting bolt.
WARRANTY
2 YEAR WARRANTY
celestron.com/support/warranties
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>