hama 00173193 Pocket 2.0 Mobile Bluetooth Speaker User Manual

: June 3, 2024
: Hama

hama 00173193 Pocket 2.0 Mobile Bluetooth Speaker

Operating Instructions

Thank you for choosing a Hama product. Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Controls and displays

Play / Pause / Accept call
On/Off Switch
Previous track / Reduce volume
Next track / Increase volume
Micro-USB charging port
Audio input
Status LED
“Charging” status LE

Explanation of warning symbols and notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note
This symbol is used to indicate additional information or important notes.

Package contents

1 x mobile Bluetooth loudspeaker
1 x micro-USB charging cable
1 x snap hook
1 x quick guide
1 x information sheet

Safety instructions

The product is intended for private, non-commercial use only.
Use the product only for the intended purpose.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
Do not use the product in areas in which electronic products are not permitted.
Only use the article under moderate climatic conditions.
Do not operate the product outside the power limits specified in the technical data.
The battery is permanently installed and cannot be removed; dispose of the product as a whole in accordance with the statutory regulations.
Do not bend or crush the cable.
Do not drop the product and do not expose it to any major shocks.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Do not open the device or continue to operate it if it becomes damaged.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Be considerate. High volumes can disturb or interfere with your surroundings.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Do not modify the product in any way. Doing so voids the warranty.
As with all electrical products, this device should be kept out of the reach of children.
While driving a car or using sports equipment, do not allow yourself to be distracted by your product and keep an eye on the traffic situation and your surroundings.
Do not incinerate the battery or the product.
Do not tamper with or damage/heat/disassemble the batteries/rechargeable batteries.

Switching on/off

Press and hold the function key (2) for approximately 3 seconds to switch the loudspeaker on / off.
An audible signal sounds and the status LED (1) starts to flash.

Note – Automatic switch-off
Please note that the loudspeaker will switch itself off after 8 minutes of inactivity (no audio playback / no Bluetooth function).

Charging

Warning – rechargeable battery

Only use suitable charging devices or USB connections to charge the product.
Do not use defective chargers or USB ports and do not attempt to repair them.
Do not overcharge the product or allow it to completely discharge.
Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric pressures (such as at high altitudes).
Charge regularly (at least quarterly) during periods of prolonged storage.

Note – Waterproof properties

Carefully seal the micro-USB port after the charging process to ensure that the product is waterproof.
Be aware that water can influence the range and sound of the loudspeaker.

Note

Do not charge the product on your PC / laptop USB port. This can cause damage to the USB port.
Use the enclosed USB charging cable only for this loudspeaker – not for other devices.

Open the cover and connect the loudspeaker

Open the seal on the micro-USB port.
Connect the supplied micro-USB charging cable to the micro-USB port (5) on the loudspeaker.

Connect the free plug on the micro-USB charging cable to a suitable USB charger. To do this, consult the operating instructions for the USB charger you are using.

Charging process

The “Charging” status LED (8) starts to light up red.
Once the battery is fully charged, the status LED (8) will go out.
The actual battery life will vary depending on how you use the device, the settings and the ambient temperatures (rechargeable batteries have a limited life).

Note – charging process

A complete charging cycle takes about 3 hours.
The loudspeaker’s rechargeable battery can be charged both when it is switched on and off.
If the battery capacity is less than 10%, a warning sound is heard twice. This information is only provided if the loudspeaker is switched on.

Waterproof properties

The loudspeaker has been tested to ensure it is waterproof according to IPX7 and therefore maintains its functions even if immersed in water up to 1mdeep for up to 30 minutes.

Liquids against which the device is waterproof as specified:

✓ fresh water, tap water, water from a swimming pool, sea water
✕ Liquids other than those specified above (soapy water, water containing cleaning agents or bath additives, shampoo/conditions, water from hot sources, etc.)

Note – Waterproof properties
Be aware that, on contact with water, all charging ports must be sealed.

Operation

Bluetooth

Note

Check whether your mobile device (MP3 player, mobile phone, etc.) is Bluetooth-capable.
Note that the maximum range for Bluetooth is 10 meters without obstacles such as walls, people, etc.
Ensure your Bluetooth-enabled device is switched on and that Bluetooth is activated.
Ensure that the loudspeaker is within the Bluetooth range of max. 10 metres.

Ensure that the loudspeaker is switched on

Check the status of the status LED (7)
If the status LED (7) is flashing quickly, the loudspeaker is searching for a connection.
If the status LED (7) is flashing slowly, the loudspeaker is already paired with a Bluetooth device.

Use your device to search for the loudspeaker.
Open the Bluetooth settings on your device and wait until the list of found Bluetooth devices shows Hama Pocket 2.0.
Select Hama Pocket 2.0 and wait until the loudspeaker is shown as connected in the Bluetooth settings of your device. An audible signal confirms the successful connection.

Note – Bluetooth password

Some terminal devices require a password in order to connect to another Bluetooth device.
If your device requests a password to connect to the loudspeaker, enter 0000.

The Bluetooth connection is established
An audible signal confirms the successful connection.
The status LED (7) flashes slowly white.

Automatic Bluetooth connection (after successful pairing)

Ensure your Bluetooth-enabled device is switched on and that Bluetooth is activated.
Ensure that the loudspeaker is within the Bluetooth range of max. 10 meters.
Switch the loudspeaker on.
After a successful automatic connection, the status LED (7) flashes slowly. An audible signal confirms the successful connection.

Note – connection impaired
After the loudspeaker and device have been paired, a connection is established automatically. If the Bluetooth connection is not established automatically, check the following:

In your device’s Bluetooth settings, check that Hama Pocket 2.0 is connected. If not, repeat the steps listed under points 1 and 2.
Check that your device and the loudspeaker are less than 10 meters apart. If not, move them closer together.
Check whether obstacles are impairing the range. If so, move the devices closer together.

Audio playback via an audio cable (3.5 mm jack)

Ensure that the loudspeaker is switched off.

Connection with the audio cable
Connect your mobile device (MP3 player, smartphone, etc.) and the AUX input (6) on the loudspeaker using an audio cable with a 3.5 mm jack plug.
Set the volume on your device to a low level.

Switch the loudspeaker on
Switch the loudspeaker on. A signal tone and the green status LED (7) confirm the readiness for operation.
Start audio playback on the connected device. The music playback can also be controlled from the speaker (provided the connected device supports this).

Audio playback

Start and control audio playback accordingly on the connected device. Alternatively, the audio playback can also be controlled from the loudspeaker (provided the connected device supports this).

Start playback on your device

| Volume
Briefly press the function key (4) to increase the volume.
---|---
| Briefly press the function key (3) to reduce the volume.
| Play / Pause
Press the function key (1) to start or stop the audio playback.
| Skip
Make a long press of the function key (4) to skip to the next track.
| Make a long press of the function key (3) to skip to the previous track.

Hands-free system

It is possible to use the loudspeaker like a hands-free facility for your mobile phone. The mobile phone must be paired via Bluetooth with the loudspeaker for this function.

Accept call
Press the function key (1) once to accept an incoming call.
Reject call
Press and hold the function key (1) for approx. 2 seconds to reject an incoming call.
End call
During the call, press the function key (1) once to end the call.
Last number redial
Press the function key (1) twice in succession to re-dial the last number.

Note – call quality

Please ensure you are near the loudspeaker during a call on your mobile phone in order to increase the quality of the call.

Technical data

Mobile Bluetooth loudspeaker

Rechargeable battery

Type| Lithium polymer rechargeable battery, 3.7 V, 1050 mAh/3.89Wh
Charging Time| ~3h
Operating time| Via Bluetooth: ~ 14h Via AUX: ~ 16h (depending on volume and audio content)

Care and Maintenance

Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Service and Support

Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here: www.hama.com

Recycling Information

Note on environmental protection:

After the implementation of the European Directives 2012/19/EU and 2006/66/EU in the national legal system, the following applies:
electrical and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries to the designated public collection points or to the point of sale at the end of their service lives.
Detailed information on this topic is defined in the national laws of the respective country. This presence of the above symbol on the product, operating instructions or package indicates that the product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices/ batteries, you are making an important contribution to protecting our environment.

Declaration of Conformity

Hama GmbH & Co KG hereby declares that the radio equipment type [00173193, 00173194] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.hama.com->00173193, 00173194 ->Downloads.