BUILD N DRIVE ESPFBD Remote Controller Car Instruction Manual
- September 27, 2024
- BUILD N DRIVE
Table of Contents
BUILD N DRIVE ESPFBD Remote Controller Car
Product Information
Specifications
- Product Name: Remote controller for Play Forward Build N Drive RC Trucks
- Compliance: Part 15 of the FCC Rules
- Conditions: Must not cause harmful interference, must accept any interference received
Product Usage Instructions
Getting Started
- Before using the remote controller, ensure that it is powered and within range of the RC truck.
Pairing the Remote Controller
- Follow the instructions in the RC truck manual to pair the remote controller with the vehicle.
Operating the RC Truck
- Use the directional controls on the remote controller to steer the RC truck. Familiarize yourself with the buttons for additional functions such as lights or sounds.
Maintenance
- Keep the remote controller clean and dry. Replace batteries as needed and store them in a cool, dry place when not in use.
FAQ
Q: Can I use this remote controller with other RC vehicles?
A: This remote controller is designed specifically for use with Play Forward Build N Drive RC Trucks and may not be compatible with other models.
Q: What should I do if the remote controller stops working?
A: Check the batteries in the remote controller and ensure they are properly inserted. If the issue persists, refer to the troubleshooting section in the user manual or contact customer support.
BATTERY INSTRUCTION
Open the battery protection cover
PLEASE CHARGE BEFORE USE
POWER ON/OFF
TO SEPARATE THE TOP PARTS FROM THE CHASSIS, TWIST THE KNOB ON THE BACK END OF THE CHASSIS AND PULL IT OFF
REMOTE INSTRUCTION
- Non-rechargeable batteries are not to be recharged different types of batteries or new and used batteries are not to be mixed batteries are to be inserted with the correct polarity (+ and -) exhausted batteries are to be removed from the toy the supply terminals are not to be short-circuited.
- WARNING: CHOKING HAZARD – small parts, Not for children under 3 years.
Parts Depreciation
CITY
CONSTRUCTION 1
CONSTRUCTION 2
FARM
SANITATION
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
The device has been evaluatec to meel general RF exposure requirement. The device can be used in porlable exposure condition without restriction.
MADE IN CHINA
The packaging must be retained since it contains important information.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>