IKEA LEDSJO Stainless Steel LED Wall Lamp Instructions
- September 23, 2024
- Ikea
Table of Contents
IKEA LEDSJO Stainless Steel LED Wall Lamp
Product Specifications:
- Non-replaceable light source
- Requires permanent installation by the authorized electrical contractor
- Specific materials require appropriate fittings
Product Usage Instructions
Installation in Bathrooms:
The installation of the luminaire must be carried out by an authorized
electrical contractor. Ensure that the luminaire is permanently installed in
the electric system and correctly placed in the designated zone within the
bathroom.
Light Source Replacement:
As the light source in this luminaire is not replaceable, the entire
luminaire must be replaced when the light source reaches the end of its life
cycle.
Choosing Fittings:
Different materials require different types of fittings. Always select
screws and plugs that are specifically suited to the material to ensure secure
installation.
Frequently Asked Questions
Q: Can I replace the light source in the luminaire?
A: No, the light source in this luminaire is non-replaceable. The entire
luminaire needs to be replaced once the light source reaches its end of life.
Q: Who should carry out the installation in a bathroom?
A: The installation should be done by an authorized electrical contractor
to ensure proper installation and safety compliance.
****WARNINGS
IMPORTANT!
Always shut off power to the circuit before starting installation work. In
some count, rare electrical installation work may only be carried out by an
authorized electrical contractor. Contact your local electricity authority for
advice.
INSTALLATION IN BATHROOMS
The installation shall be carried out byauthorizedised electrical contractor. The luminaire must be permanently installed in the electric system and placed in the correct zone. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material.
INSTALLATION
STEPS
A covering cap or lid must be used if the back of the lamp does not completely cover the wall box.
Design and Quality IKEA of Sweden