iCam365 Q20 Dual Lens Outdoor Camera User Guide
- September 20, 2024
- iCam365
Table of Contents
iCam365 Q20 Dual Lens Outdoor Camera
Connect the device
Download the app
Use the “Scan” function of your mobile phone to scan the QR code, download and
install the “iCam365” APP
Connect power
Connect the device to the power supply and wait for about 1 minute
Add device
- log in
- Add device
- Scan the QR code of the fuselage
- Waiting for automatic recognition
- Select the WiFi to connect to
- Waiting to configure and enter the password to the network
- The addition is complete, the device is named The device will appear on your homepage
Function Description
The app will be updated continuously, and the interface is subject to the APP.
Common problem
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received. including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help NOTE: This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, this equipment
should be installed and operated with a minimum distance of 20cm from the
radiator of your body. This device and its antenna(s) must not be co-located
or operated in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>