elago EMSPAD15W-BK 15W Wireless Charging Pad User Guide
- September 19, 2024
- elago
Table of Contents
elago EMSPAD15W-BK 15W Wireless Charging Pad B
When used with a case thicker than 3mm, charging may be difficult. For fast charging, a 20W or higher PC and QC-supported adapter are required. Products compatible with iPhone. For models prior to the iPhone 12, charging is possible after attaching a MagSafe ring or using a MagSafe Case.
LED Status
Charging Guide
- Connect the included USB-C cable.
- Attach your cell phone to the wireless charging pad.
Specifications
| Product Name | 15W Wireless Charging Pad |
|---|---|
| Model Number | EMSPAD15W-BK |
| Country of Manufacture | China |
| Name of Manufacturer | Shenzhen Powerqi Technology Co., Ltd. |
| Name of Importer/Company | ELAGO Co., Ltd. |
| Manufacturer Address | Room 201, 302, 401 of A4 Building, Block A, Fangxing |
Science and Technology Park, No.13 of Baoxian Road, Longgang District,
Shenzhen, China
Rated Input| DC 5V/3A, 9V/2.22A, 12V/1.67A
Rated Output| 5W, 7.5W, 10W, 15W
TX/RX Frequency Range| 110-148kHz (Only for EU); 115-205kHz (Only for FCC)
Max Radiated H-Field| -11.5 dBuA/m (@10m) (Only for EU)
A/S Center| 031-801-4535
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This Device may not cause harmful interference, and
- This Device must accept any interference received, including interference that may cause undesired operation.
Note : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
WARNING: Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
FCC RF exposure statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
EU
This device was tested for uncontrolled environment operations. To comply
with RF exposure requirements, a minimum separation distance of 20cm must be
maintained between the user’s body and the product.
Declaration of Conformity
Hereby ELAGO CO. LTD declares that the product type is in compliance with
Directive 2014/35/EU & 2011/65/EU. The full text of the EU declaration of
Conformity is available at the following Internet address:
https://www.elago.com
California Proposition 65
This product does not contain chemicals known to the State of California to
cause cancer and birth defects or other reproductive harm.
elago | MAKE DETAILS, MAKE HISTORY | SAN DIEGO, CALIFORNIA
FAQ
Q: What should I do if my phone is not charging?
A: Ensure that your phone case is not thicker than 3mm. Also, make sure you
are using a 20W or higher PC and QC-supported adapter.
Q: How do I know if the charger is working?
A: Refer to the LED status indicators. A green light indicates charging
mode, while a red light indicates a charging error.
Q: Can I use this charger with an older iPhone model?
A: Yes, for models prior to iPhone 12, charging is possible after attaching
a MagSafe ring or using a MagSafe Case.