PALADONE 33CM Flow Lamp Instructions

: September 13, 2024
: Paladone

Table of Contents

PALADONE 33CM Flow Lamp
INSTRUCTIONS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PALADONE 33CM Flow Lamp

WORKING TITLE: FLOW LAMP 33CM INSTRUCTIONS
DATE OF CREATION: 09/05/25
This image remains the intellectual copyright of Paladone Products Ltd

INSTRUCTIONS

Warnings! BEFORE YOU USE YOUR LAMP.

Check the lamp for damage before each use.
If the lamp is damaged with cracks or scratches, switch off and unplug the lamp and discontinue use immediately.
For indoor use only.
The USB cable and power supply used with this item is to be regularly examined for damage to the cord, plug, and other parts, and in the event of such damage, they must not be used until the damage has been repaired.
Keep out of reach of young children.
This product is not to be directly connected to the mains supply.
Installation and operation of this lamp should be carned out by an adult.
If the liquid in the lamp becomes exposed to floor/furnishing, remove and dispose as much of the liquid as possible, then use recommended cleaning methods for removing coloured water for whatever floor/furnishings are affected.
If liquid content comes in contact with the skin, wash hands thoroughly with clean, fresh water.
This item can be used with a compatible mains powered transformer.
This must be a short-circuit proof safety isolating transformer according to IEC 61558-2-16 or a toys transformer according to IEC 61558-2-7. Max Output 5V DC 1A. LEDs are not replaceable.
Use 3 x 1.5v type AAA batteries.
Take care to hit battenes observing the plus & minus markings.
Replace all used batteries at the same time.
Do not mix used and new batteries, rechargeable, different types (alkaline or carbon zinc), or different brands of batteries.
Only use batteries of the same type. Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed trom the product before being charged.
Rechargeable batteres are only to be charged under adult supervision.
The supply terminals are not to be short-circuited. Exhausted batteries are to be removed immediately.
To insert / replace batteries: Unscrew battery cover and insert batteries, observing polarity guide.
Ensure battery cover is securely screwed in place before use.
The crossed out wheelie-bin symbol on this product is to remind you that waste electrical and electronic products, batteries and accumulators should not be disposed of with household waste.
If you are unable to reuse or recycle your article it should be disposed of at a civic amenity site/local authority recycling facilities.
Packaging (and instructions if included) must be kept since they contain important information.

WARNING : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference radio requency enely and, roof instale and use i scordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.