onn 100005529 Wireless Earphones User Guide
- September 11, 2024
- Onn
Table of Contents
onn 100005529 Wireless Earphones
FAQs
Q: How do I power on/off the earphones?
A: Press and hold either side of the device to power on or off.
Q: How long does it take to charge the earphones when the battery is empty?
A: It takes approximately 1.5 hours to charge the earphones when the battery is empty.
Q: Where can I provide feedback about the product?
A: You can share your feedback by scanning the QR code with your Walmart app.
Get to Know Your Wireless Earbuds
- Model: 100005529
- Speaker Diameter: 10mm
- Speaker Impedance: 162+15%
- Sensitivity: 103÷4 dB at 1kHz/-10dBFS
- Speaker Driver Rating Power: 3mW
- Charging Cable: 25cm
- 12 hours of total playtime
- IPX4 waterproof rating applies to the earphones, not to the charging case.
What’s in the Box
Check to make sure you have everything below
- Earphones x1 Pair
- Charging Case x1
- Micro-USB charging cable x1
- Manual/Warranty card x1
Get Started
On/Off & Pairing
- For your first-time use, take out both earphones from the charging case, do not push any buttons, they will go to pairing mode automatically. Powe Connect your device by searching for “Onn TWS Earphones”.
- Onn TWS Farohones will automatically reconnect to the last paired device.
- If you want to pair with another device, please disconnect Bluetooth on your last paired device if it is nearby. Take out both earphones from the charging case and power them off. When the earphones are turned off, press and hold R side earphone 5sec to reactive it from connecting to another device, then power on the L side as well.
Enjoy Your Music
Hear a Clear Phone Call
Charge Your Earphones
- Earphones charging: red lights on
- Earphones fully charged: lights off
FCC
FCC Statement
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occurin a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Produced for Walmart Inc. Bentonville, AR 72716
- FCC ID: 2ADZH-ONN5529
- FCC ID: 2ADZH-ONN5530
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>