TRYONE PT01 Remote Control Page Turner User Manual
- September 6, 2024
- TRYONE
Table of Contents
TRYONE PT01 Remote Control Page Turner
User Manual
Remote Control Page Turner
Packing List
Screen Sensor Clip
Remote Control
Instructions for Use
- Hold the Power Switch of the Screen Sensor Clip for 2 seconds, the Indicator light will flash, indicating that it is in an unconnected state.
- H old the Operation Key of the Remote Control for 2 seconds, the Indicator Light on the Screen Sensor Clip will stay on, indicating a successful c.annedion.
- Attach the Screen Sensor Clip to the Kindle. ensuring the Ensure the metal sensor is in contact with the screen.
- Press the Operation Key on the Remote Control to turn the pages normally.
How to turn off the device?
- Press and hold the power switch on the Screen Sensor Clip for 4 seconds until the indicator light turns off, powered off successfully.
- Press and hold the Operation Key on the Remote Control for 4 seconds until the indicator light on the Page Turner turns off, powered off suc.cessfully.
How to charge?
Connect the 2-in-1 Type-C Cable to the USB-A charger block. Connect the Type-C
ports separately to the Screen Sensor Clip and the Remote Control. A red light
indicates charging, and the red light turr,s off when charging is complete.
The Screen Sensor Clip can be attached anywhere on the left or right side of the Kindle. Please ensure that the metal sensor head is iri proper contact with the screen.
If the Screen Sensor Clip obstructs the text, manually adjust the page margins on your Kindle to iml)rm,e your reading experience.
FAQ
-
Q: What to do if the page turner is not working?
A: -
Make sure both the Screen Sensor Clip and the Remote Control are powered on and properly connected. During connection, the Remote Control should have a press-to-light function, and the Screen Sensor Clip should remain continuously lit.
-
Ensure the metal sensor head of the Screen Sensor Clip is in proper contact with the Kindle screen.
-
If the problem persists, please contact us.
Q: What to do if the Screen Sensor Clip obstructs the text?
A: -
Adjust the position of the Screen Sensor Clip.
-
Adjust the page margins on the Kindle screen.
-
Q: How long does it take for the page turner to turn off automatically?
A: If the page turner has not been used for 60 minutes, it will turn of automatically and will need to be repaired to work.
How to use Hand Strap?
Screen Sensor Clip
Remote Control
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance
FCC Requirement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfull interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>