UEFA FT-14256 Football Goal Set Instruction Manual
- September 5, 2024
- UEFA
Table of Contents
FOOTBALL GOAL SET
IAN 445822_2307
FOOTBALL GOAL SET
Assembly instructions
FT-14256 Football Goal Set
Before reading, fold out the illustration page and get to know all of the functions of your unit.
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY!
Congratulations!
You have chosen to purchase a high-quality product. Familiarise yourself with
the product before using it for the first time.
Read the following assembly instructions and the safety information carefully.
Use the product only as described and only for the given areas of application.
Store these assembly instructions carefully. When passing the product on to
third parties, please also hand over all accompanying documents.
Package contents/parts list
(Fig. A)
2 x goal frame part (1)
2 x goal frame part (2)
2 x goal frame part (3)
2 x goal frame part (4)
2 x goal frame part (5)
2 x goal frame part (6)
2 x goal frame part (7)
2 x goal frame part (8)
4 x screw (9)
4 x washer (10)
1 x hex key (11)
11 x ground peg (12)
19 x fastening band (13)
5 x rope (14)
1 x goal wall (15)
1 x goal net (16)
4 x hook and loop fastener (17)
1 x assembly instructions
Technical data
Dimensions (assembled):
approx. 240 x 170 x 85cm (W x H x D)
Date of manufacture (month/year):
11/2023
Delta-Sport Handelskontor GmbH hereby declares that this product meets the
following basic require- ments, as well as other important regulations:
2009/48/EC – Toy Safety Directive
Intended use
This product has been designed for private use.
The product is a toy.
The product does not meet the requirements for sports goals of the standard
DIN EN 748:2006.
This goal was designed exclusively for soccer games and for no other purpose.
Safety information
Mount the goal net in such a way that an opening larger than the mesh size of the goal net does not develop.
Risk of injury!
- Warning. Not suitable for children under 36 months. Choking hazard. Small balls.
- Warning. Strangulation hazard. Long cord.
- Warning. Only for domestic use.
- The product is intended for outdoor use.
- Warning. Age recommendation: from six years of age.
- Warning. None of the packaging materials or attachments are part of the toy itself, and must always be removed for safety reasons before the product is given to children to play with.
- Children may only play with the product under adult supervision.
- Adult assembly required.
- Do not make any modifications to the product.
- The product must be placed on level ground when in use.
- An unobstructed area with a radius of 3m is needed when setting up the goal.
- Make sure that all the ground pegs are anchored deep in the ground.
- Warning. Do not climb onto the product.
- The product is not a toy or climbing apparatus! Ensure that people, especially children, do not pull themselves up on the product or lean against it. The product may tip over.
- Check regularly to make sure all screws are tight.
- Always safeguard the product from falling over, even if it is not currently being used.
- Choose ground that is as solid and level as possible for erecting the product. Sandy surfaces reduce stability. Make sure that the ground provides a firm hold for the pegs. Otherwise they could come loose and pose a hazard (e.g. tripping or falling on them).
- Never hit the ground pegs into the ground with too much force! If necessary, Use a loop to lengthen the guy lines and reposition the ground peg.
- When using the product, always make sure that all the metal parts are firmly connected and the tubes are not sticking out.
- When using the product, always make sure that the goal net is not damaged. Users’ heads can get stuck in a damaged goal net.
- Immediately remove any sharp-edged objects from the area.
- Warning. Keep away from open fire!
- Check the product for damage or wear before each use. Use the product only if it is in perfect condition!
- Defective parts must be replaced in accordance with the manufacturer’s instructions.
Preventing damage to the product!
-
It is possible that the protective coating on the metal tubes may become scratched due to the interlocking of the metal parts, thereby causing rust to develop. Grease these parts slightly therefore, preferably even before use.
-
To enjoy this product for as long as possible, only mount the goal wall (15) when you want to use it.
When you are not using the goal wall, take it down and store it in a dry, temperature-controlled room. -
Do not expose the goal wall to direct sunlight when it is being stored. If you are not using the football goal for an extended period, in winter for example, we recommend dismantling the product and storing it likewise in a dry and temperature-controlled room.
Erecting the goal wall
Note: because of its size, the product should be assembled by at least
two adults.
Setting up the frame (Fig. B)
- Connect the goal frame parts together according to their numbering. When connecting the parts, make sure that the safety locking snaps into the openings provided.
- Screw the marked parts in place with the enclosed screws and washers as shown.
IMPORTANT! First tighten the screws on top of the goal frame and then tighten the lower screws.
Note: if the locking pins cannot be pressed in to connect the pipe sections together, press the pin’s holding device into the correct position inside the pipe.
Assembling the goal net
(Fig. C)
Hang the goal net (16) over the assembled goal frame and then move it into the
correct position.
The little coloured flags mark the upper corner points of the goal.
- Attach the goal net to the crossbars (7) + (8) using the preinstalled hook and loop fasteners.
- Attach the goal net to the goal frame using the ropes (14). To do this, take note of how the ropes are allocated in Figure C.
- Attach the end of a rope to the goal frame.
Then draw the rope through the mesh of the goal net and wind it between the meshes around the goal frame. Finally fasten the end of the rope to the goal frame again.
Note: you can also use the individual enclosed hook and loop fasteners (17) for mounting the goal net.
Securing the goal
After the goal has been set up, it must be secured against falling over.
Use the enclosed ground pegs (12) to do this. Make sure that the pegs are
completely pushed into the ground at an angle. Secure five ground pegs at the
bottom of the goal posts as shown in Figure C and six pegs to the bottom of
the goal wall as shown in Figure D.
Note 1:
Please check the quality of the subsoil. In loose subsoil the ground pegs can
easily come loose and then pose a danger for the players.
Note 2:
If you are not using the goal, you must remove the goal wall so that the wind
will not damage it.
Maintenance
- At regular intervals, check the goal in its assembled state for damaged parts, sharp edges and to make sure that the anchors are functioning properly.
- Make sure that the ground pegs are completely sunk into the ground. This is the only way to prevent the goal from tipping over.
- Each time you assemble the goal, check the individual parts of the product for damage and sharp edges.
- Do not use any damaged parts or parts with sharp edges. Replace them immediately with technically flawless parts.
Storage information
Please keep the assembly instructions and the accessories in a safe place for
future use.
Storage, cleaning
When not in use, always store the product clean and dry at room temperature.
Clean only with water and wipe dry afterwards with a cloth.
IMPORTANT! Never clean the product with harsh cleaning agents.
Disposal
Dispose of the product and packaging materials in accordance with current
local regulations. Store the packaging materials (foil bags, for example) out
of the reach of children. For further information about disposal of the
product no longer needed, contact your local council. Dispose of the product
and the packaging in an environmentally friendly manner.
The Recycling Code distinguishes different materials to be returned for recycling. The Code consists of the recycling symbol for the recycling process and a number that identifies the material.
Notes on the guarantee and service handling
The product was produced with great care and under continuous quality control.
DELTA-SPORT HANDELSKONTOR GmbH gives private end customers a three-year
guarantee on this product from the date of purchase (guarantee period) in
accordance with the following provisions. The guarantee is only valid for
material and manufacturing defects. The guarantee does not cover parts that
are subject to normal wear and tear and that are thus considered wear parts
(e.g. batteries) and it does not cover fragile parts such as switches or parts
that are made of glass.
Claims under this guarantee are excluded if the product has been used
incorrectly, improperly, or contrary to the intended purpose, or if the
provisions in the instructions for use were not observed, unless the end
customer proves that a material or manufacturing defect exists that was not
caused by one of the aforementioned circumstances.
Claims under the guarantee can only be made within the guarantee period by
presenting the original sales receipt. Please therefore keep the original
sales receipt. The guarantee period is not extended by any repairs carried out
under the guarantee, under statutory guarantees, or as a gesture of goodwill.
This also applies to replaced and repaired parts.
If you wish to make a claim please first contact the service hotline mentioned
below or contact us by e-mail. If there is a guarantee case, then the product
will be repaired or replaced free of charge to you or the purchase price will
be refunded, depending on our choice. There are no further rights from the
guarantee.
Your legal rights, in particular guarantee claims against the respective
seller, are not limited by this guarantee.
IAN: 445822_2307
GB Service Great Britain
Tel.: 0800 404 7657
E-Mail: deltasport@lidl.co.uk
IE Service Ireland
Tel.: 1800 101010
E-Mail: deltasport@lidl.ie
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>