Crocpad Anchor Point Instructions
- August 24, 2024
- Crocpad
Table of Contents
Crocpad Anchor Point
How to add or replace a new anchor point
-
Use a drill with a 48mm hole saw
-
Drill a hole in a piece of timber and use it as a pilot hole
-
Place the piece of timber with pilot hole on the mat where you need to make the hole – at least 400mm away from the edge
-
Use the hole saw to drill carefully until you go completely through to the other side.
-
Now you have the hole ready, insert the spacer into the anchor point as shown in Picture 2
-
Insert the anchor point with the spacer into the hole.
-
Now turn the mat and insert the second part of the anchor point into the hole as shown in picture 3
-
Insert the screws and lock as shown in picture 4
Specifications
- Product: Anchor Point Kit
- Manufacturer: CrocPad
- Website: www.crocpad.com
- Required Tool: Drill with a 48mm hole saw
- Material: Spacer, Screws
Frequently Asked Questions (FAQ)
Q: Can I use a different size of hole saw for this product?
A: It is recommended to use a 48mm hole saw as specified for optimal
performance and fit.
Q: What should I do if the anchor point does not fit securely after
installation?
A: Double-check that you have followed the instructions correctly. If the
fit is still not secure, contact customer support for assistance.