HAVIT HV5822T-BLK Nella Surface Mounted Downlight Instruction Manual
- June 4, 2024
- havit
Table of Contents
HAVIT HV5822T-BLK Nella Surface Mounted Downlight
Product Specifications
Nella Surface Mounted Downlight Installation Instructions
Product Specifications
Model No.| HV5822T-BLK| HV5822T-WHT| HV5823T-BLK| HV5823T-WHT| HV5824T-BLK|
HV5824T-WHT| HV5825T-BLK| HV5825T-WHT
Name| Nella Rotatable
Material| Aluminium
Colour| Black| White| Black| White| Black| White| Black| White
IP Rating| IP54
Input Voltage| 240v
Protection Class| 1 (Requires Earth)
Lamp Base| Built in LED
Lamp Wattage| 1x 7w| 1x 12w| 1x 18w| 1x 24w
Colour Temp| TRI-Colour – 3000k , 4000k, 5500k| TRI-Colour – 3000k , 4000k,
5500k| TRI-Colour – 3000k , 4000k, 5500k| TRI-Colour – 3000k , 4000k, 5500k
Lumens| 395lm, 485lm, 465lm| 790lm, 880lm, 855lm| 1415lm, 1600lm ,1485lm|
2100lm, 2320lm, 2270lm
CRI| > 80
Wiring| Parallel
Dimmable| Yes – Triac Dimmable
Warranty| 3 Years Replacement*
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- Aluminium and 304SS fittings must not be installed within 5km of any salt water environments.
- All o-rings and seals must be in place correctly to maintain warranty
- This form may be updated at any time due to product improvements, please check online installation form for most current version.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off )
- Remove base plate by loosening allen screws on side of fitting.
- Unplug fitting from driver and set fitting aside
- Install base plate in desired location using appropriate screws for application.
- Connect the cable: Use wire with earth, connect earth first then positive and then neutral
- Reconnect plug from fitting to base plate.
- Fitting is preset to 3000k, To change slide switch inside fitting to desired colour temperature
- Reattach fitting to base plate and tighten allen screws making sure these are tight.
- Rediredt head by gently moving bottom half of fitting to desired direction.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Contact Details
143 Beauchamp Road Matraville NSW 2036 Australia
Tel: 02 9381 8300
Fax: 02 9666 8881 Email: sales@havit.com.au Web:
www.havit.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>