Supplying Demand SD5304491583 Compressor Harness Adapter Installation Guide
- August 26, 2024
- Supplying Demand
Table of Contents
SD5304491583 COMPRESSOR
HARNESS ADAPTER
SD5304491583 Compressor Harness Adapter
IMPORTANT: Unplug your appliance and turn off power at the breaker before
servicing. If you have doubts or are unfamiliar with this type of installation
work, seek the services of a qualified Service Technician. Supplying Demand
assumes no responsibility for the improper installation of this product.
This part is to be used on units which possess a machine harness mating to a
compressor using discreet electrical components or an older combo device being
replaced by a compressor with start package electrical type components
requiring a Molex type connector.
INSTALLATION INSTRUCTIONS
-
Locate the harness adapter, butt connectors and heat shrink tubing that is included in the compressor kit.
-
Cut the existing connectors off of the unit’s compressor wires and install the butt terminals provided.
-
Locate the harness adapter provided with the compressor kit and slip the provided heat shrink tubing over the wires of the harness adapter prior to installing.
-
Insert the wires of the harness adapter into the butt connectors and crimp with tool.
NOTE: On 115v units, the red and blue wires of the unit should match the red and blue wires of the harness adapter. -
Connect the Molex connector to the compressor controller making sure the tab snaps into place.5.
-
Install the controller on the compressor making sure that the compressor clip is in place.6.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>