SWITCH WORKS 240-MBS3-SWE12 Alpha12 Switcher Box Mounting Kit Instruction Manual
- August 16, 2024
- SWITCH WORKS
Table of Contents
SWITCH WORKS 240-MBS3-SWE12 Alpha12 Switcher Box Mounting Kit
Product Specifications
- Model: 240-MBS3-SWE12
- Compatibility: 2019-Up Mercedes Benz Sprinter Van (Gen 3)
- Manufacturer: SSV Works
- Warranty: Limited 1-year warranty for electronics, limited lifetime warranty for non-electronic parts
WARRANTY INFORMATION:
All SSV Works Non-Electronic Parts are covered by a limited lifetime warranty
against defects in material or workmanship. All SSV Works Electronics are
covered by a limited 1 year warranty against defects in material or
workmanship. Labor for replacement of defective components is not covered.
Contact SSV Works for further warranty information.
Please read and understand these instructions completely before installation to avoid possible injury, or damage to the accessory or vehicle.
Product Usage Instructions
Tools Needed for Installation:
- Plastic Card
- Drill
- 6mm Drill Bit
- Small Screw Driver
- Pick Tool
Alpha12 Overhead Mounting Kit Assembly
- Insert a credit card in the middle front side of the overhead console to release the lock and slide out the overhead console.
- Unplug the connectors behind the overhead console.
- Unhook the (2) rubber limiter bands in the sunglass holder.
- Remove the plastic rotary damper by carefully pressing on the lock.
- Use a small screwdriver to carefully pry out the sunglass holder and lay the Sprinter mounting bracket in the sunglass holder cavity.
- Mark screw holes using a pick tool.
- Use a marker to emphasize the screw hole points.
- Use a 6mm drill bit to drill 4 holes.
- Join the Sprinter fascia and mounting bracket using (4) #7-19 screws to secure them together.
- Line up the 15-button controller on the Sprinter ALPHA12 overhead mounting kit. Pay attention to the orientation of the controller.
- Use (4) 4-40x.375 Thread Cutting screws to secure the controller to the mounting kit.
- Insert the controller cable through the plastic rotary damper hole.
- Hold the Sprinter mounting bracket in place while fastening the back side with screws.
Switch Works Brain Module Installation:
Tools Needed for Installation:
- Phillips Screw Driver
- 13mm Wrench
Follow similar steps as above for installing the brain module, ensuring proper alignment and secure fastening.
Frequently Asked Questions
Q: What is covered under the warranty?
A: All SSV Works Electronics are covered by a limited 1-year warranty against defects in material or workmanship. All SSV Works Non-Electronic Parts are covered by a limited lifetime warranty against defects in material or workmanship.
Q: What should I do if I encounter difficulties during installation?
A: If you face challenges during installation, please contact SSV Works for further assistance and guidance.
2019-Up Mercedes Benz Sprinter Van (Gen 3) Alpha12 Switcher Box Mounting Kit
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone:
818-991-1778 | Fax:
866-293-6751
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>