KONIX Pac-Man Wireless Headphones Instructions
- August 17, 2024
- KONIX
Table of Contents
KONIX Pac-Man Wireless Headphones
PACKAGE CONTENTS
PRODUCT DIAGRAM
- Voice assistant button
- Volume up (+)
- Multifunction button
- Volume down (-)
- Microphone
- 3.5mm Audio jack
- Charging Port
- LED indicator
CHARGING
- Connect one end of the USB C cable to the USB C port on the headset and the other end to a power source.
- The LED turns red while the headset is charging.
- The LED turns off when the headset is fully charged.
- The headset cannot be turned on while charging.
POWER ON/OFF
ON
OFF
Power on| Press and hold the multifunction button for 3s| Blue LED flash
alternately, the sound signal in a rising tone
---|---|---
Power off| Press and hold the multifunction button for 3s| Quick red LED
flash, the sound signal in a falling tone
BLUETOOTH PAIRING
- Power on the headset; the headset automatically enters pairing mode when turned on.
- In case the headset is not in pairing mode, keep on long pressing the multifunction button for 5s to turn on the Bluetooth pairing mode, until the LED starts flashing alternately blue and red.
- On your device, select « KX-PACMAN-GH» from the Bluetooth device list to pair the headset.
CONTROLS
| Play/pause | Press the multifunction button |
|---|---|
| Volume up | Press the volume up button |
| Volume down | Press the volume down button |
| Next track | Long press the volume up button |
| Previous track | Long press the volume down button |
| Answer/hang up incoming calls | Short press the multifunction button |
| Reject calls | Long press the multifunction button for 2s |
| Call back | Double press quickly on the multifunction button |
| Turn on voice assistant | Press the dedicated voice assistant button |
AUX-IN
- Plugging in a 3,5mm cable will automatically switch to AUX-IN mode, and Bluetooth mode will turn off.
- When using AUX-IN mode, audio and volume control need to be done on the device.
OTHER FUNCTIONS
- If the headset is left idle and the link is lost, the blue and red LEDs will flash alternately
- If the headset is running on low battery, then the red LED will flash 2 times every 30 seconds until it is plugged into a charging source.
TROUBLESHOOTING
Q: My device doesn’t find the headset on the Bluetooth device list
Check if the Bluetooth headset is powered on; if it is powered on and still doesn’t connect, reboot both devices.
Q: After connecting the headset, disconnection or noise occurs.
- Check if the headset is sufficiently charged.
- There may be obstruction between both devices, or the Bluetooth range may be overextended.
SPECIFICATIONS
| Driver size | 40 mm |
|---|---|
| Frequency response | 20-20 KHz |
| Impedance | 32 Ω |
| Sensitivity | 100 ±3 dB |
| Bluetooth version | 5.3 |
| Bluetooth range | > 10 m |
| Sound channel output | Stereo |
| SNR | > 90 dB |
| Playtime | ± 30 h |
| Standby time | ± 200 h |
| Charging time | ± 2.5 h |
| Battery type | Li-polymer |
| Battery Capacity | 250 mAh |
SAFETY INFORMATION
- Do not place the headset in a high temperature environ-ment or directly exposed to the sun.
- Do not place the headset in an excessively moist envi-ronment or submerged into water, keep the headset dry.
- To prevent hearing damage, make sure that the volume on your music player is turned down before connecting your headphones. Noise levels are measured in decibels (dB). Exposure to any noise at or above 85 dB can cause gradual hearing loss.
- Do not use the headset in an unsafe environment: while operating a vehicle, crossing streets, or during any activity or in any environment where your full attention to your surroundings is required.
- Warning: Prolonged listening to music at high volume can cause permanent hearing damage.
Regulatory compliance information
- If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste.
- Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
- ©2023 Konix. Innelec Multimedia – Konix, 45 rue Delizy, 93692 Pantin Cedex, FRANCE.
- The Konix brand is a trademark of Innelec Multimedia S.A. All other trademarks are the property of their respective owners. Photos and illustrations are not binding.
- All rights reserved. Made in PRC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>