Buffy M08S Selfie Stick User Manual

Buffy M08S Selfie Stick

Product Information

Specifications:

• Compliance: Part 15 of FCC Rules
• RF Exposure: Meets general RF exposure requirement

Product Usage Instructions

Compliance with FCC Rules:
Ensure that the device is operated in accordance with Part 15 of the FCC Rules. The device should not cause harmful interference and must accept any interference received.

Antenna Placement:
To optimize reception and minimize interference, consider the following:

• Reorient or relocate the receiving antenna for better signal reception.
• Increase the separation between the equipment and the receiver to reduce interference.
• Connect the equipment to a power outlet on a different circuit from the receiver.

Professional Assistance:
If you experience difficulties or need help with setup, consult the dealer or an experienced radio/TV technician for assistance.

FAQ

Q: What should I do if my device is causing interference?
A: If your device is causing interference, try reorienting the antenna, increasing separation from other equipment, or consulting a professional for assistance.

OVERVIEW

How to use

1. Power on: press and hold the camera buttonfor 3 seconds.
2. Bluetooth pairing: the indicator flashes for 3 seconds to enter the pairing state and the white indicator flashes. Use the mobile phone to search for “VIP” to match. After the pairing is successful, the white indicator goes out.
3. Photographing: When the self timer isconnected to the mobile phone, briefly pressthe photo key, and the white light flashes.
4. No pairing: after power on, in the state of no pairing connection, it will automatically shut without operation for 5 minutes,
5. Pairing: after powering on, when the self-timer isconnected to the mobile phone, it will enter the sleep state without operation for 10 minutes, and it will automatically shut down after 10 minutes.
6. sleep: After entering the sleep state, press the photo key to connect the mobile phone.

Key Function

Use after taking out the Selfie and connecting the phone.

How to open a tripod

The bottom of the handle can be opened toopen the tripod

Clip phone

Use one end of the phone to push the clip upwards

Take out the Bluetooth

Diagram

Adjust various angles

Adjust various angles to shoot

Extendable

Extended and stable pole can be extended

How to use fill light

Press and hold to turn on and off The first long press to start, light cold white: (50%),

• Second press: (100% cold white)
• Third press: (50% warm white)
• Fourth press: (100% warm white)
• Fifth press : (red light)
• Sixth press : (green)
• Seventh press: blue light,

Press 1-7 for the eighth time and flash : ( 0. 5 seconds),
Press the ninth stop in the current: Cycle in sequence.

Specification

(Batteries must not be exposed to sunlight, fire or similar excessive heat )

Remid
The selfie stick is compatible with Android 4.4 and above & iOS 5.0 and above. (Android device: lf you change your volume key function on the camera, be sure to change it to the default value.Or take a picture and let the selfie stick to work normally)

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user′s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.ct.

The device has been evaluated to meet general RF exposure requirements.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>