NIKOK 81491 Full Funcion Radio Control Vehicle Instruction Manual
- August 5, 2024
- NIKOK
Table of Contents
NIKOK 81491 Full Funcion Radio Control Vehicle
WARNING:
- CHOKING HAZARD — Small parts.
- Not for children under 3 years.
Retain the packaging and manual for future reference as they contain important information.
Battery Installation
Vehicle
Transmitter
GENERAL BATTERY SAFETY INFORMATION
Read and follow operating instructions.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the product.
- The supply terminals are not to be short-circuited.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the product before being charged.
- Rechargeable batteries are only to be charged by an adult.
- Dispose of battery(ies) safely.
- Do not dispose of this product in a fire. The batteries inside may explode or leak.
- Batteries should be changed by adults only.
- Wires are not to be inserted into socket outlets.
- Only charge using the provided USB charger cable.
HOW TO PAIR
- Turn on transmitter. Red LED will blink while searching for vehicle.
- Turn on vehicle. Red LED will turn solid (pairing successful).
VEHICLE OPERATION
- Any of the following conditions may interfere with the behavior and function. The transmitter signals can easily be interrupted. Improper handling may hamper the performance of the vehicle.
- (Run time is Approximately 12-15 min., Approximately operating distance range 150ft., Approximately top speed of 10mph)
SAFETY PRECAUTIONS
Remember to avoid water, heat, sand and high impact!
- Read the operating manual thoroughly before playing.
- Users should keep strict accordance with the instruction manual while operating the product.
- Keep vehicle away from wet surfaces or rain.
- Avoid collision on hard surfaces.
- Do not operate your vehicle on the streets.
- Turn off the transmitter/charger and the toy when not in use.
- Remove batteries from transmitter/vehicle when not in use.
- Only use included USB charger to charge battery pack.
Disposal
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you cadrop off your waste equipment for recycling, please contact your local city oce, your household waste disposal service or the shop where you purchased the product.
BATTERY INSTRUCTIONS
IMPORTANT!
7.4V battery pack is NOT fully charged prior to shipping and must charged 4-5 hours before the first and second use.
- Insert the supplied 7.4V battery pack securely into the charger as shown.
- Plug the charger into a standard USB power source (only use included USB charger to charge battery pack).
- Allow the battery pack to charge for a minimum of 4-5 hours on the initial two charges. Subsequent charges require only 4 hours. (Red light on while charging/Green light on when charge is complete)
- Remove charger and battery from outlet. Unplug the battery pack from the charger by depressing the catch on one side of the connector, and gently pulling the plug halves apart. (Fig. 1)
- For optimal charging, plug USB charging cable into a USB wall charger (not included) into a standard 110/120V indoor electrical outlet.
NOTE: Battery Pack will become warm after charging or during use. Make certain to allow the Battery Pack to cool before recharging. Charging a warm Battery Pack will greatly reduce it’s life. Do not overcharge the battery pack which may result in battery failure.
ATTENTION PARENTS:
The battery charger & battery pack need to be periodically examined for potential hazards. Any potentially hazardous parts need to be repaired or replaced. The charger used with the toy are to be regularly examined for damage to the cord, plug, enclosure and other parts, and that, in the event of such damage, the toys must not be used with this charger until the damage has been repaired.
FCC STATEMENT
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
**This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause interference
- this device must accept any interference, including interference that may cause undesired operation of the device.
The device is compliance with RF field strength limits, users can obtain
Canadian information on RF exposure and compliance.
This Class B digital apparatus complies with Canadian ICES-003. Conforms to
ASTM F963 standard.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Requirement
- The device has been evaluated to meet general RF exposure requirement.
- The device can be used in portable exposure condition without restriction.
FAQ
- Q: Can I use different batteries with this product?
- A: The product is designed to operate with 1.5V AA/LR6/R6/R6P batteries. It is recommended to use the specified batteries for optimal performance.
- Q: How do I know when the battery is fully charged?
- A: The charger’s red light indicates charging, and the green light indicates a complete charge. Ensure you follow the charging instructions provided in the manual.
- Q: What should I do if I encounter difficulties operating the toy?
- A: If you have questions or face challenges while using the toy, do not return it to the store. Contact customer service at 888-656-5869 for assistance.
Contact
If you have questions or difficulty operating this toy
DO NOT RETURN IT TO THE STORE
Call us Toll-Free: 888-656-5869
Monday – Friday between 10:00am – 4:00 pm Pacific Standard Time or email us
at: customerservice@nkok.com
Irwindale, CA 91706, USA. www.nkok.com –
customerservice@nkok.com
Made in China. 81481-4-81491-2-060424-V1.6
©2024 NKOK, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>