36.0057 Vanity Units Bathroom Furniture Instruction Manual

Table of Contents

Mark two holes levelly on the wall.
Drill the holes using the proper size drill bit.
Insert expansion wall plugs or appropriate alternative wall fixings.
Screw in the tapping screws and add cover caps.
When fitting the basin, apply an adequate amount of silicone between the basin and the unit to prevent water ingress.
Mark holes levelly on the wall.
Drill the holes using the proper size drill bit.
Insert expansion wall plugs or appropriate alternative wall fixings.
Screw in the tapping screws.
Apply silicone between the basin and unit to prevent water ingress.
Ensure proper ventilation in the bathroom.
Avoid abrasive cleaning materials and acidic substances for cleaning.
Clean with agents having a PH of 7.
Keep the vanity unit dry and wipe off any spillages promptly.
Check hinges and sliders every 6 months and tighten any loose screws.

Q: Can I install the vanity unit by myself?
A: It is recommended to use qualified plumbers and have two people for installation due to the size and weight of the units.
Q: How often should I check the hinges and sliders?
A: It is advised to check hinges and sliders every 6 months for proper functioning and tighten any loose screws.
Q: What should I do if I notice a damaged component during installation?
A: Never install products or components that appear damaged. Contact customer support for assistance.

PLEASE READ THE BELOW NOTES BEFORE INSTALLING YOUR VANITY UNITS

Use protective gloves and eye protection at all times
Please use qualified plumbers to install the vanity unit
2 people are required to install the units
Check the parts are fully supplied
Never install products or components that look damaged
Hinges for doors and sliders for drawers may need to be checked and adjusted to achieve proper position after installation
Please avoid direct sunlight as this will affect the painted surface color change
If fixing to a stud or paneled wall, the proper framework is required to support a wall-hung unit

NECESSARY TOOLS (not supplied)

Installation for Floorstanding Vanity Units

Mark the two holes levelly on the wall.
Drill the holes using the proper size drill bit.
Insert expansion wall plug or appropriate alternative wall fixing.
Screw in the tapping screws.
Add cover caps on the screws.
When fitting the basin to the unit, adequate silicone is required between the basin and unit to prevent potential water ingress.

Installation for Wall Hung Vanity Units

Mark the holes levelly on the wall.
Drill the holes using the proper size drill bit.
Insert expansion wall plug or appropriate alternative wall fixing.
Screw in the tapping screws.
When fitting the basin to the unit, adequate silicone is required between the basin and unit to prevent potential water ingress.

Drawer slider adjustment

If you need some fine adjustment, turn the screw clockwise to to get the drawer “up”, turn the screw anti-clockwise to get the drawer “down”

Soft closing hinge adjustment

Wall hanging bracket adjustment

Make sure your bathroom is well-ventilated
Do not use abrasive cleaning materials which will hurt the surface finish
Do not use any cleaning with acidic substances or soda. We suggest using cleaning agents with a PH of 7
The vanity unit must be kept dry and not subject to continuous moisture
All spillages and splashes must be wiped off
Do not lean on fully opened doors or drawers
Check the hinges and sliders every 6 months and any loose screws must be tightened

Read User Manual Online (PDF format)