NEFF S875HKX21G Dishwasher Integrated User Guide

Table of Contents

Before using for the first time, read the instruction manual and the safety information it contains.

Tip: Connect your appliance to a mobile device. You can conveniently change all settings using the Home Connect app.

Install the Home Connect app on your mobile device and fol-low the instructions.
Scan the QR code with the Home Connect app.

You can find an overview of the water hardness values that can be selected here.
A table of country-specific units can be found in the instruction manual.

Setting the water softening system

Press .
To open the basic settings, press
Setup 3 sec. for 3 seconds.
- The display shows Hxx.
- The display shows set .
Press Start repeatedly until the right water hardness has been set.
To save the settings, press
Setup 3 sec. for 3 seconds.

The program data has been measured in the laboratory according to European standard EN 60436.
The consumption figures depend on the program and additional function selected.
The running time will change if the rinse aid system is switched off or rinse aid needs to be added.

Adding special salt

To avoid damage to the appliance, only add special salt to the dispenser for special salt just before the program starts.

Unscrew the lid of the dispenser for special salt and remove it.
On initial start-up: Fill the dispenser right up with water.
Add the special salt to the dispenser. The water in the dispenser is displaced and forced out. Never add detergent.
Place the lid back on the dispenser and turn to close.

Adding rinse aid

Adding detergent

Load the tableware.
Only clean tableware that is suitable for dishwashers. Remove large remnants of food from the tableware. Check that the spray arms can rotate freely.
Add detergent.
Switch on the appliance ⁠.
Select the program.
Start the program
Remove the tableware at the end of the program.
To cancel the program, press Reset for 4 sec. for approx. 4 seconds. The program is canceled and ends after approx. 1 minute.

Cleaning filters

After each wash check the filters for residue.
Turn the coarse filter anticlock-wise 1 and remove the filter system 2 ⁠.
Pull down the microfilter to remove it.
Press the locking catches 1 together and lift the coarse filter out 2 ⁠.
Clean the filter elements under running water.
Re-assemble the filter system.
Insert the filter system into the appliance and turn the coarse filter clockwise. Make sure that the arrow markings match up.

Unscrew the upper spray arms 1 and pull down to remove 2 .
Pull up the lower spray arm to remove.
Check the outlet nozzles on the spray arms for blockages under running water and remove any foreign bodies.
Insert the lower spray arm.
- The spray arm clicks into position.
Insert the upper spray arms and screw firmly in place.

Disconnect the appliance from the power supply.
Remove the filter system.
Scoop out any water.
Prise off the pump cover using a spoon and grip it by the crosspiece.
Lift the pump cover inwards at an angle and remove.
Remove any remnants of food and foreign bodies in the area of the impeller.
Insert the pump cover 1 and press down 2 ⁠.
- The pump cover clicks into position.

The filters in the water connection of the supply or AquaStop hose are blocked.

Q: How do I connect my appliance to Home Connect?
- A: Install the Home Connect app on your mobile device and follow the provided instructions to connect your appliance.
Q: When should I add a special salt to the dishwasher?
- A: Add special salt just before starting a program to avoid damage to the appliance.
Q: What should I do if I need to cancel a program?
- A: Press and hold the cancellation button for approximately 4 seconds to cancel a program.