ONLYTOP 9 Series 1200mAh Portable Charger User Manual
- July 31, 2024
- ONLYTOP
Table of Contents
ONLYTOP 9 Series 1200mAh Portable Charger
Thank You
Thank you for purchasing this product.
Please read and carefully keep the user manual for reference before using this
product.
Basic Specifications
Product Model : S9
Battery Type : Lithium-ion Battery Battery Capacity: 1200mM
Input Specifications : USB Type-C: 5V/1 A(Max)
Output Specifications : Watch Wireless Charging: 3W Max
input interface: USB Type-C
Output Interface: Watch Wireless Charging
Product Dimensions : 2.042. 750. 56in(527014.2mm)
Product Diagrams
Product Accessories
S9 Portable Charger, User Manua, USB-C Cable
Product Operation Instructions
Watch Charging : Press the switch once to activate the watch charging mode (with in 1 minute before the green light turns off).
Stop Charging : Press the switch twice to deactivate all operational modes of the charger.
Button Usage Tips : While in the off state, single-click the button to activate the output. The white LED indicator light turns on, simultaneously, the green indicator light for watch charging illuminates, initiating the watch charging mode. If the watch isn’t being charged, the green light will turn off after 1 minute, and the watch charging mode will stop. Double-click the button to completely shutd0Vv11 the charger.
Charge the portable charger:
Connect the charging cable from the charger to the Type-C input port of the
portable charger.
The display will flash, indicating it’s charging.
Charging the watch with S9: Briefly press the switch to turn on the portable power bank. Within 1 minute before the green light turns off, place the watch on the charger to start charging. (Note: The watch can only be charged when the green lights on.)
Cautions
- Please read this manual carefully to understand how to use this product correctly.
- Avoid using this product in high temperature or humid environments, and avoid dropping or damaging the product.
- Keep the product in a safe place away from children’s reach.
- For safety reasons, do not disassemble the product on your own, as it may pose safety risks. If the battery swells, deforms, or gets wet, please stop using it immediately.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 0 centimeters from thedevice surface at all times, except for non-repetitive patterns with transient timeintervals in the order of a second. Only in the stated conditions, the device is shownto fully comply with the FCC RF Exposure requirements of KDB 447498.