Slice 2023 Electric Ducted Fan Glider Instruction Manual

: July 30, 2024
: Slice

Table of Contents

Slice 2023 Electric Ducted Fan Glider
Product Information
Product Usage Instructions
Unpacking
Control horns for ailerons and flaps
Installation
Specifications
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Slice 2023 Electric Ducted Fan Glider

Product Information

Specifications:

Wing span: 3200mm
Length: 1865mm
Wing aerofoil: RC series
Control surface: ailerons, flaps, elevator, rudder
Flyweight: 4500g
Elevator: Up 5 mm, Down 4mm
Ailerons: Up 12 mm, Down 6mm
Rudder: 8mm left/right
Center of Gravity (CG): 145-160 mm from leading edge

Product Usage Instructions

Control Horns Adjustment for Ailerons and Flaps:
The control horns for ailerons and flaps need to have about a 10-degree offset towards the leading edge for proper functionality.

Electric Ducted Fan Installation:
Ensure the electric ducted fan is installed properly with a diameter of 48mm. Follow steps 1, 2, and 3 in the manual for correct installation.

RX and Batteries Frame Assembly:
Assemble the Rx and Batteries frame according to the provided instructions and securely glue it in place.

Frequently Asked Questions (FAQ)

Q: What is the recommended Center of Gravity (CG) for this product?
A: The recommended Center of Gravity (CG) is between 145-160 mm from the leading edge of the aircraft.

Unpacking

Please unpack the plane carefully making sure that you have retrieved all of the small parts.
Don’t throw the box out until you are 100% sure it’s empty!
Check that all the parts are supplied.
If any are missing please contact your vendor immediately.

Control horns for ailerons and flaps

Make-up control rods and clevises using the parts supplied.
Control horns for ailerons and flaps
Zero the servos by using your R/C unit.
Remember! Aileron servo arms can be set to 90 degrees, but the flaps need to have about a 10-degree offset towards the leading edge.
When the wiring harness is positioned inside the wing and accessible, servos can be installed.
First, check the position of the servos to make sure they are all symmetrical (In the same place) in each wing.
Install the control rods onto the servos and check that they do not bind, and are snug but not too loose or too tight.
Tape the control surfaces flat with masking tape.
Assemble the completed set of servos, and control rods.
When you are satisfied that you have the correct position for the servo – glue them in using a slow-set epoxy,
When cured and secure, connect the servos to the wiring harness and check for zeros, then for free and adequate movement. Adjust using the clevises if needed. (See the control settings section a the back of this manual for control movements)
Finally, check the fit of the servo hatch covers and sand if not snug.
Then put some double-sided tape on the underside and install all on to the servos hatches.