VOLTMAT 31561996 Camping Air Conditioner Instruction Manual

OPERATING INSTRUCTIONS
Bahag No. 31561996
Bahag No. 31540269 BAHAG AG
Gutenbergstr. 21,
68167 Mannheim
Germany
service@bauhaus.info
Camping Air Conditioner

SAFETY INSTRUCTIONS

IMPORTANT!
AIR CONDITIONERS MUST ALWAYS BE STORED AND TRANSPORTED UPRIGHT, OTHERWISE IRREPARABLE DAMAGE MAY BE CAUSED TO THE COMPRESSOR; IF IN DOUBT WE SUGGEST WAITING AT LEAST 24 HOURS FOLLOWING INSTALLTION BEFORE STARTING THE UNIT.

WARNING
When using this air conditioner, t is important that you always observe the safety regulations. This prevents the risk of personal injury, electric shock and product damage.
Therefore, read all instructions beforehand.

• Read the manual before use.
• If the terms of use are not followed, the manufacture will not be liable for any damage or injury resulting from the use of this device.
• Keep the manual, warranty certificate and sales receipt.
• Children should be supervised to ensure that they do not play with the appliance.
• This appliance is not intended to be used by children under 8 years of age or by persons with limited physical, sensory or mental capabilities or insufficient experience and knowledge, unless they have been accompanied or have been instructed o n how to use the appliance by a person who s responsible for their safety.
• Don’t insert your fingers or any hard object to wind guide bar of the air outlet.
• The plug should be in good condition and can’t be damaged. Never repair the device yourself if the appliance, the cord or the plug s damaged. Always have this done by the manufacturer or a qualified technician.
• The device is not suitable for commercial use.
• Always use and store the device n a dry place.
• Never use accessories that are not recommended by the manufacturer.
• Recommended operation environment temperature: 35°C.
• This appliance is only suitable for caravan use and for the purpose for which it is intended.
• It is prohibited to modify this product (or parts of t).
• Never connect multiple electrical appliances to a power outlet. This prevents a bad connection and high heat load.
• Distance to burning objects at least 2 meters due to fire prevention measures.
• A distance of 50cm should be left between the device and other objects from front side and 20cm should be left between the device and other objects from left and right sides.
• Users are strictly forbidden to add refrigerant themselves.
• Do not pull directly on the hose or destroy it with sharp objects. If the hose is found to be damaged, discontinue use and contact the distributor for repair.
• Details of type and rating of fuses: 250VAC, T3.15A

Installation location of the air conditioner
The air conditioner must be placed on a firm, flat surface (note: the air conditioner must not be tilted or tilted) when the appliance is in use. This air conditioner may not be installed in the following places:

• Near strong heat sources, vapors and flammable or explosive gas.
• In an environment that contains chemicals (evaporating substances, organic solvent s, etc.), as soon as it rains, the air conditioning must be removed from the window.

Also take the following regulations into account:

• The product must be kept upright at all times and n all cases. Do not hold the device sideways or upside down.
• Try to keep the air conditioner straight when moving or carrying it. Make sure it is not shaken or dropped.
• Make sure the air supply is not clogged and remains well ventilated.
• Do no insert objects through the openings of the air inlet and outlet. Objects can en counter electrical parts or the fan n this way and could be dangerous.
• Do not place heavy objects on the product.
• Remove the plug from the socket before moving the air conditioner, performing maintenance, cleaning or not using it for a long time.
• Do not pull the plug to move the machine.
• Clean the dust screen of the air supply at least once a month.
• If the machine will not be used for a long time, t must be stored n a cool and dry p lace.
  Clean and dry the air conditioner well in advance.

TECHNICAL DATA

63 dB(A)
Dimensions outside unit| 44×21.5×35.5cm| Net weight| 20,5kg

PACKING LIST

DESIGNATION OF PARTS

ACCESSORIES:

OPERATION OF CONTROL PANEL

1. POWER
   Press this key to turn the device on and off.
   When the air conditioner is switched on, the temperature is set to 22°C by default. The temperature sensor measures the ambient temperature and if exceeds 22°C, the outdoor unit starts to work to bring the temperature down. If the ambient temperature already below 22°C, then the outdoor unit does not start.

2. MODE
   Press this key to select cooling, fan, dehumidification modes;
   In standby/turned on mode, by pressing this key to set timing on/off.

3. TEMPERATURE I TIME ADJUSTMENT
   In cooling mode, press the key to increase or decrease the temperature, the setting temperature adjustable from 16-30°C;
   In timer mode, press the key to adjust time to turn on/turn off the machine.
   Press Up/Down key at the same time to transfer between °C and °F.

4. FAN SPEED
   Press the key to choose ow/high fan speed.

5. SLEEP MODE
   Press the key to enter or quit sleep mode. After 20 seconds, all lights and the digital display turn off and the air conditioner goes to sleep. The indoor unit fan continues to run at low fan speed.

6. DISPLAY WINDOW
   Check temperature and time from this window.

7. SWING
   Press fan speed and sleep mode key at the same time to turn on/off swing function.

INSTALLATION OF THE AIR CONDITIONER

1. Unpack the machine and accessories and check that the hose between the indoor and outdoor unit is properly connected. Also check whether the condensation drain has a rubber cover. Finally, check whether the accessories are complete.
   2.1 Install the accessories as shown n the picture. Connect the outer bracket to the support block and the inner bracket by tightening the M6 screws. This is how you form the carrying handle. 2.2 Place the shockproof rubber dampers on the back of the outdoor unit. 2.3 Install the bracket as shown n the figure below. Install the indoor and out door units on the bracket to fix the two parts. To secure the units to the bracket, tighten the M6 screws in the appropriate holes. 2.4 Install the indoor unit on the bracket and tighten the bracket properly. Next, wrap the protection sleeve on the hose between the outdoor and indoor unit. (See the illustration below ) 2.5 Install the complete unit in the caravan window and tighten the bracket properly.

ERROR CODE LIST

If the device does not work or works insufficiently:
Check if an error code is visible n the display, refer to the code table for a solution.
If no error code s visible in the display, go through the error table for a possible solution.

Error codes

Error code| Cause| Solution
FL| Water full alarm| Take off rubber stopper and empty the water.
E1| System temperature sensor fault| Replace System temperature sensor
E2| Room temperature sensor fault| Replace room temperature sensor
EF| Indoor motor fault| Replace the motor.
E4| Freeze protection| Check that the air outlet s not blocked, keep the air deflector open.

TROUBLE SHOOTING GUIDE

Failure guide

Problem| Cause| Solution
The device does not turn on| No power| Turn power on
Damaged electrical outlet| Turn off the power and
Unknown reason| check/repair the power outlet
Little air displacement or limited cooling effect| The lowest ventilation setting is selected| Contact the dealer Select the high ventilation speed mode
The air filter is dirty| Check and clean the filter
The air supply or exhaust of the indoor unit is blocked| Check that the unit is not blocked and remove the obstruction
The air supply or exhaust from the outdoor unit is blocked| Check that the unit is not blocked and remove the obstruction
The ambient temperature is too low or high| Die Umgebungstemperatur muss zwischen 18 and 40 liegen°C
Insufficient voltage from the power supply| Consult an installer or use a different power connection
Air displacement only but no cooling effect| The device runs n ventilation mode| Select the cooling mode(A/C)
The cooling mode has just turned off automatically| Wait about 3-Sminutes until the thermostat switches on again
Abnormal sounds or vibrations| The mounting brackets are not properly installed on the vehicle, or the device mounting screws are not sufficiently tightened| The mounting brackets are not properly installed on the vehicle, or the device mounting screws are not sufficiently tightened
Water is leaking from the indoor unit| The rubber stopper on the bottom of the indoor unit is missing, or is not pressed enough| Check or replace the rubber stopper
The device is at an angle| The device must be mounted horizontally (maximum angle <3°)
The appliance emits a unusual odor| There is a serious problem| Switch off the device immediately and contact the dealer

MAINTENANCE

Declaration:

1. Ensure the machine is unplugged before maintenance.
2. Do not use gasoline or other chemicals to clean the unit;
3. Do not wash the unit directly;
4. If the air conditioner is damaged, please contact the dealer or repair shop.

Cleaning
Caution: Unplug the power cord before cleaning the maintenance.

1. Air filter
   • It is important to regularly remove the dust from the filter.
   • Remove the filter as shown in the picture below.
   • Clean the filter with tap water and I or a vacuum cleaner to remove any dirty from the filter.
   • Do not use water hotter than 40°C for cleaning and do not expose the filter to the sun.
   • Make sure the filter has dried before putting it back n the air conditioner.

2. Clean the Air-conditioner Surface
   • First clean the surface with a neutral detergent and wet cloth;
   • Then dry the device thoroughly with a dry cloth.
   • Do not allow water or deterrent to enter the machine.
   • Do not clean the air conditioner with an aggressive cleaning agent and/or petrol.

Storage
If you are planning to store the machine without needing to use it for a long time, please remove the drain cover from the drainage hole at the bottoms both of indoor unit and outdoor unit, and drain all the condensation water appropriately in available place.

1. Remove the unit from the window.
2. Remove the rubber seal from the indoor unit and outdoor unit, drain the condensate water.
3. Keep running in fan mode to make the internal dry.
4. Turn off the conditioner and pull down the plug.
5. Wash the filter then install.
6. Remove all the brackets on the air conditioner, install the brackets of the indoor unit on the outdoor unit, assemble as shown in the figure below, and then store the unit against the wall.
7. Store the air conditioner in a cool and dry place.
8. We recommend that you put the air conditioner back in its packaging when you store it. This prevents dirt and dust from collecting on the air conditioner.

SMART HOME WIFI CONNECTION GUIDE

Network Module Features

Install App
Download the “Smart life” app from the Play Store (Android) or App Store (iOS).

https://smartapp.tuya.com/smartlife

Register
If you do not have a Smarter Home account, register or sign in with a verification code sent by SMS.
To register:

1. Tap to enter registration page
2. The system automatically recognizes your country/ area. You can also select your country code manually. Enter your mobile phone number/ email address and tap “Next”.
3. If you choose the mobile phone number option, then enter the verification code in the message sent to you by SMS. Set a password as prompted and press “Confirm” to finish your registration.

Add Device Through Network

1. Power conditioner on, when conditioner under standby mode, press the “FAN”button for 3 seconds to enter Wifi-connect mode.
2. Open Smart Home app and tap “+” in the upper right to add a new device through the network,
3. Ensure the device ‘s indicator light rapidly flashes (2 times per second) and tap “Confirm light is rapidly flashing”.
4. Select Wi-Fi network (note: network must be 2.4Ghz band) and enter the password . The device will commence the pairing process and connect to the app.
5. After successfully configuring the devices, the AC will be shown on the smart home page. Tap to enter its control page.

ENVIRONMENTAL PROTECTION AND DISPOSAL

Note: Environmental protection and disposal
Consumers are legally obliged to dispose of electronic devices, lamps and batteries properly at the end of their service life.
These can be returned free of charge to public collection points or to retailers. The deletion of personal data is the responsibility of the consumer. Light bulbs and batteries that can be removed safely and are not permanently nstalled must be removed in advance for separate disposal. State law regulates the details of legally compliant disposal. The crossed-out wheelie bin label marks electrical devices and batteries that must under no circumstances be disposed of with household waste after their service life. Symbols placed under the garbage can indicate any ingredients it may contain (lead = Pb, mercury= Hg, cadmium= Cd).
This separation is necessary because batteries and electrical devices are both valuable resources and contain substances that are harmful to people and their environment. By recycling, collecting and reusing suitable batteries and electrical devices, you contribute to the preservation and protection of the environment and human health.

ERP

| 31561996 31540269
---|---
D escription| Symbol| Unit| Value
Rated cooling efficiency| Prated C| kW| 1,465
Rated heating effciency| Prated| kW|
Rated power consumption for cooling| PEER| kW| 0,56
Rated power consumption for heating| PCOP| kW|
Energy Efficiency Index for Cooling| EERd| | 2,62
Energy Efficiency Index for heating| COPd| | _
Power consumption in off -mode thermostat| P 10| | –
Power consumption in standby mode| P SB| | 2
Electrical energy consumption of air conditioners -single channel -two -channel (cooling)| SD: Q SD DD: Q DD| SD: kWh/h DD: kWh/a| 0,546
Sound power level| L WA| dB (A)| 63
Global warming Potential| GWP| kg CO2 equivalents| 3
Company information| BAHAG AG Gutenbergstr. 21, 68167 Mannheim, Germany service@bauhaus.info

Hereby, BAHAG AG declares that the radio equipment type 31561996&31540269 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address

www.Bauhaus.info/documents  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>