CASA CBA-15 Series Quadra 5 Piece Bathroom Hardware Set Installation Guide
- July 24, 2024
- casa
Table of Contents
CASA CBA-15 Series Quadra 5 Piece Bathroom Hardware Set
Specifications
- Product Series: Quadra CBA-15**
- Warranty: 1 year from the date of purchase
- Cleaning Instructions: Clean with a soft, damp cloth only. Avoid scrub pads, detergents, or cleansers.
Product Usage Instructions
Installation Considerations
It is recommended to mount the product to a wall stud for best results. Keep
the box and packaging materials until installation is complete.
Safety Tips
- Do not use the product as a grab bar.
- Exercise caution when drilling into walls to avoid hitting electrical or plumbing lines.
Cleaning Instructions
Use a soft, damp cloth to clean the product. Avoid scrub pads, detergents, or
cleansers to protect the finish.
Tools you may need
- Electric drill
- Tape measure
- Hammer
- Phillips screwdriver
- Pencil
- Lever
- 1/4 in. drill bit
- Silicone sealant
Two-Post Installation
- Drill 5/16 holes and install drywall anchors using the provided pin.
- Secure the mounting plate in place.
Installation Guide
Series: Quadra CBA-15**
Installation Considerations
These products should be located and mounted to a wall stud. While it is
possible to mount them to any surface, a stud mounted product will yield the
best results.
Keep this booklet and the receipt (or other proof of date and place of
purchase) for this product in a safe place. The receipt is required to request
warranty parts.
Please keep the box and packaging materials until your product is completely
installed.
SAFETY TIPS
WARNING!
This item is not designed for use as a grab bar. Do not mount in locations
where the product is likely to be used as a grab bar.
WARNING
Use caution when drilling into walls to avoid drilling into electrical and
plumbing lines hidden within wall.
Cleaning Instructions
To maintain and protect the ne luster of all bath accessories, clean with a
soft, damp cloth only. DO NOT USE scrub pads,
detergents or cleansers as they may harm the protective nish of your bath
accessories.
Damage to the product caused by improper care or the use of improper cleaning
agents is not covered by the warranty.
Warranty
Warranted to be free from manufacturing defects for a period of one (1) year
from the date of purchase.
Tools you may need
Dimensions
Single-Post Installation
- Loosen the set screw and remove the mounting plate from the accessory.
- Position the mounting base and verify plumb. Mark the positions of the screw holes.
- Drill 1/8″ holes. Secure the mounting plate.
- Drill 5/16″ holes. Use the provided pin to install the drywall anchors. Secure the mounting plate.
- Drill 1/4″ holes. Insert ceramic anchors. Secure the mounting plate.
- Slide the accessory onto the mounting plate. Tighten the setscrew.
Two-Post Installation
- Loosen the set screw and remove the mounting plate from the accessory.
- Position the mounting plate and verify plumb. Mark the positions of the screw holes.
- Drill 1/8* holes. Secure the mounting plate.
- Drill 5/16″ holes. Use the provided pin to install the drywall anchors. Secure the mounting plate. Drill 1/4* holes.
- Insert ceramic anchors. Secure the mounting plate.
- Slide the accessory onto the mounting plate. Tighten the setscrew.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>