MODECOM Breeze ARGB Flow Installation Guide
- July 15, 2024
- MODECOM
Table of Contents
MODECOM Breeze ARGB Flow
Accessories
- A MOTHERBOARD SCREWS
- B HOD/SSD SCREWS
- C PSU/GPU SCREWS
- D STANDOFFS
- E COPPER PILLAR SLEEVE
- F LONG COOLING SCREWS
- G ZIP TIE
- H BUZZER
Panel 1/0
- POWER
- HDD INDICATOR LIGHT
- POWER INDICATOR LIGHT
- RESET / LED
- MIC
- SPEAKER
- USB 3.2 GEN 7*
- USB 3.2 GEN 1*
- USB-C
OVERVIEW
Installation of ARGB hub
FUNCTION
- Short press LED button to cycle through LED modes.
- Press the LED button for 3 seconds to change mode to the motherboard control.
- Press the LED button for 5 sec- onds to turn off the LED power.
- Press the LED button to back to the manual control.
- Through the mainboard’s PWM to control the PWM fan speed.
- Memory Function after power off.
CONNECT CONTROLLER TO PROPER FAN CONNECTOR ON M/B. (FOR THE ASUS AURA MOTHER- BOARD, CONNECT TO LED CONTROL CONNECTOR ON M/B] CONNECT POWER SUPPLY TO SATA. CONNECT LED SW.
DIMENSION
INSTALLING MOTHERBOARD
Installing power supply
Installing GPU
Installing HDD & SSD
Quick start guide/ installation
- Open the housing.
- Install all computer components fol- lowing the instructions in the individual assembly instructions for each compo- nent.
- Mount in the housing and connect the power supply to the required com- ponents, following the installation in- structions of the power supply and the instructions of the components that require its connection. The power supply is mounted in a tunnel, in the lower part of the case, with the fan facing outside the case (down).
- Check the correct assembly of com- ponents and the connection of power plugs.
- Close the housing.
- Connect the monitor, keyboard and other accessories to the computer.
- Connect the power cord to the socket in the power supply and to the 230V mains socket.
- Set the power switch on the PSU housing to the l position (if present).
DISPOSAL
This device was designed and made of high-quality reusable ma- terials and components. If the device, its packaging, user’s manual, etc. are marked with crossed waste container, it means they are subject to segregated household waste collection in compli- ance with the Directive 2012/19/UE of the European Parliament and of the Council. This marking informs that electric and electronic equipment shall not be thrown away together with house- hold waste after it’s been utilised. The user is obliged to bring the utilised equipment to electric and electronic waste collection point. Those running such collection points, including local collection points, shops or commune units, provide convenient system enabling to scrap such equipment. Appropriate waste management aids in avoiding consequences which are harmful for people and environment and result from dangerous materials used in the device, as well as improper storage and processing. Segregated household waste collection aids recycle materials and components of which the device was made. A household plays crucial role in contributing to recycling and reusing the waste equipment. This is the stage where the basics are shaped which largely influence the environment being our common good. Households are also one of the biggest users of small electrical equipment. Reasonable man- agement at this stage aids and favours recycling. In the case of improper waste management, fixed penalties may be imposed in accordance with national legal regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>