Parrot Uncle Remote Control Ceiling Fan Instructions
- July 3, 2024
- Parrot Uncle
Table of Contents
Remote controller
GENERAL INFORMATION
INSTALLING RECEIVER IN CEILING FAN
A. Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect power by removing fuse or switching off
circuit breaker. Do not use with solid state fans. Electrical wire must meet
all local and national electrical code requirements.
B. Electrical rating: 110/240V 50/60Hz MAX. Motor watts: 40W MAX. Light watts:
60W Otherwise power can cause serious injury or death.
C. Installing receiver in fan: (FIG.2)
a. Remove power from the circuit.
b. Remove ceiling fan canopy from the mounting bracket.
c. Disconnect existing wiring between ceiling fan and Supply in electrical
junction box.
d. Make connections as follows, using the wire nuts supplied: (FIG.1)
CONNECT TO
Green fan wire ….Bare supply wire
Black receiver wire(AC IN L) ….Black supply wire
White receiver wire(AC IN N) ….White supply wire
Brown receiver wire(TO MOTOR 1) ….Brown fan wire
Black receiver wire(TO MOTOR 2) ….Black fan wire
Red receiver wire(TO MOTOR3) ….Red fan wire
Blue receiver wire(For light) ….Blue light wire
White receiver wire(For light) ….white light wire
OPER ATING TRA NSMITTER :
A. Install 203 2 3 volt bat tery.
(To prevent damage to trans mitter , remove the bat tery if not used for a
long time).
B. Store the trans mitter away from excessive hea t or humi dity.
C. Oper ating the but tons on the pan el of the trans mitter . (FIG.3)
WARNING:
Statement according to FCC part 15.21: Changes or modifications not expressly
approved by the party responsible for compliancecould void the user’s
authority to operate the equipment.
D. Keep pressing the light button in excess of
0.7 second and it becomes a dimmer.
D. Set ting the codes on the receiver:
The Learn Key must be pressed with in 5 seconds, after pressing the Power
button .
If not, please press the Power button to restart.
Keep pressing the button LEAR N key in excess of 3 second it becomes a LEARN
status .
The receiver can remem ber the last codes status .
The ceiling fan light flash two times . (FIG.4)
FCC Statement:
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. -
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital, pursuant to Part 15 or the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may casue harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/ TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>