Shearwater 55366-01 Wireless Charger User Guide
- July 3, 2024
- SHEARWATER
Table of Contents
Shearwater 55366-01 Wireless Charger
Specifications :
- Input: 5V/1.5A
- Output: 5V/0.6A
- Working Power: 2.5W
- Working Distance: 3mm
- Charging Efficiency: 70%
- Standard: QI
- Quality: Quality and meet CE/FCC/ROHS
- Operation Frequency: 111KHZ-205KHZ
- H-field: -11.27 dBA/m @ 10m
- Hardware: 55366-01-RevA
- Software: 55366-01-RevA
Product Usage Instructions
- Avoid contact with water or other liquids.
- If cleaning is necessary, ensure the charger is disconnected from the power supply.
- Operate in an environment with a temperature not exceeding 40°C.
- To comply with FCC’s RF Exposure guidelines, maintain a minimum distance of 20cm between the device and your body.
- Use only the supplied antenna.
Application Devices:
- The wireless charger is compatible with Peregrine devices.
- FCC ID: 2AO24-55366-0
Compliance Information
Sharewater declares that the radio equipment type smartwatch wireless
charger complies with Directive 2014/53/EU. The EU declaration of conformity
can be found at: www.sharewater.com
Note :
The text provided at the end of the manual seems to be corrupted or
incomplete, and further clarification may be needed from the manufacturer.
Frequently Asked Questions (FAQ):
-
Q: Can the wireless charger be used with devices other than Peregrine?
A: The charger is optimized for Peregrine devices, but it may work with other QI-compatible devices as well. However, performance may vary. -
Q: What should I do if the charger comes into contact with liquid?
A: Disconnect the charger immediately and allow it to dry completely before using it again to avoid any damage.
Wireless Charger
Model:55366-01
User Guide
Thank you for purchasing and using this product!
Please read this Operation Instruction carefully and keep it properly before
using this product.
Product Specification
- Input:5V/ 1.5A
- Output:5V/0.6A
- Working Power:2.5W
- Working Distance:3mm
- Charging Efficiency:70%
- Standard :QI
- Quality: Quality and meet CE/FCC/ROHS .
- Operation frequency:111KHZ-205KHZ .H-field:-11.27 dBμA/m @ 10m
- Hardware:55366-01-RevA
- Software:55366-01-RevA
Application Devices
- Compatible with Peregrine
- FCC ID:2AO24-55366-01
ATTENTION
- Please keep the charger away from water or other liquid.
- lf you need to clean the charger, please make sure it is not connected power supply.
- Using Environment temperature remains 40 C
- To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Hereby, Sharewater declares that the radio equipment type smartwatch wireless charger is in compliance with Directive2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.sharewater.com
This equipment has been tested and found to comply with the limits for a WPC device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Caution Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product. Note: This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
- If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from the to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
100-10200 Manufacturer Information
- Name: Shearwater Research Inc. Address:100-10200 Shellbridge Way, Richmond, BC V6X2W7 Canada Importer Information
- Name: FINISTERRE UK LIMITED
- Address: UNIT 6 WHEAL KITTY WORKSHOPS ST.AGNES, ,CORNWALL, UK, TR5 ORD
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>