Godox K2 LiteFlow Cine Lighting Reflector Instruction Manual

Godox K2 LiteFlow Cine Lighting Reflector

Foreword

Thank you for purchasing!
Introducing the innovative and unique lighting diffusion system by Godox – the Cine Lighting Reflector. With its precision-designed reflector, this cutting- edge system accurately guides the light source to the desired lighting positions, allowing for precise control over the scattering of light while minimizing reliance on flags or frames on the set. What’s truly astonishing is the meticulously crafted aluminum coating surface, which boasts only 3% light loss and 100% color accuracy.

The reflector is available in four different sizes to accommodate various lighting requirements: 2.75″ × 2.75″, 5.91″ × 5.91″, 9.84″ × 9.84″ “, 19.69″ × 19.69”.

• DIFF 1(Blue color): Hard ray of light(diffusion rate is 13.2%)
• DIFF 2(Yellow color): Medium soft ray of light(diffusion rate is 52%)
• DIFF 3(Green color): Soft ray of light(diffusion rate is 95%)
• DIFF 4(Red color): Soft strip ray of light(diffusion rate is 94%)

The above data is provided by Godox laboratory. Lighting Effects Display (Using LiteFlow 50 as an example)

Cautions:

1. The reflector is prone to scratching. Please use specialized gloves when handling.
2. To ensure the reflector remains free from stains, it is recommended to clean it immediately after use. Failure to do so may result in difficulty cleaning the reflector if oil stains are left unattended for an extended period.
3. The reflector is prone to scratching, so handle with care during transportation or installation.

Name of Parts

1. Reflector
2. Slide Rail
3. Slot
4. Corner Guards
5. Safety Wire Hole

Cine Reflector Cleaning Instructions

1. Please wear gloves to clean during use
2. Spray an appropriate amount of cleaning solution evenly onto the surface of the reflector.
3. Let the cleaning solution sit for 15-30 seconds to thoroughly break down any oil stains.
4. Use a cleaning cloth to dry the reflective surface.

Note: To ensure cleaning effectiveness, please do not reuse the cleaning cloth.

Installation of WMS / WMR

Depending on your requirements, you can install either the Wheel Mount Stud WMS or the Wheel Mount Receiver WMR.

• The WMS features a 5/8″ male socket port. By installing WMS you can insert a connecting rod with a 5/8″ female socket.
• The WMR features both vertical and horizontal female socket ports. By installing WMR you can insert a connecting rod with a male socket.

Installing WMS/WMR : To install WMS/WMR, loosen the wheel on the WMS slider by turning it counter-clockwise. Then insert it into the groove at the bottom of the reflector and slide it to the desired position. Once in position, turn the wheel clockwise to tighten and secure it in place.

What’s Inside LiteFlow K2

Optional Accessories

Specification

Wechat Official Account

0755-25723423 B3f: godox@godox.com

GODOX Photo Equipment Co., Ltd.

• Add.: Building 2, Yaochuan Industrial Zone, Tangwei Community, Fuhai Street, Bao’an District, Shenzhen 518103, China
• Tel : +86-755-29609320(8062)
• Fax : +86-755-25723423
• E-mail: godox@godox.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>