EMX RS232 Patriot Reader Serial Port Kit Instructions
- June 24, 2024
- EMX
Table of Contents
Patriot Reader
Serial Port Kit Instructions
RS232 Patriot Reader Serial Port Kit
This kit provides a USB-to-serial (RS-232) interface for all Patriot readers.
It is intended to be used with a laptop or desktop PC running the TRES Reader
Setup Software.
Step 1: Open the clamshell case with a small slotted screwdriver to
expose the PCB with screw terminal blocks: Step 2: Remove the PCB and
connect the reader wires to the terminals according to the table:
| Wire Color | Terminal |
|---|---|
| Brown | 2 |
| White | 3 |
| Purple | 5 |
Step 3: Connect the PCB’s female DB9 socket to the male DB9 connector on
the USB-to-DB9 cable: Step 4: Connect the USB end of the cable to your
computer. Your computer will automatically detect the cable and enumerate a
COM port for it.
Step 5: To check which COM port the cable is on, open Device Manager and
look under the “Ports (COM and LPT)” heading. Tip: You can quickly get to
Device Manager by hitting the Windows key and typing “dev”, then select Device
Manager.
In “Ports (COM and LPT)” you should see a device listed as “Prolific PL2303GT
USB Serial COM Port” followed by the COM port number, as shown below: 
Note this COM port number.
Step 6: Open the TRES Reader Setup software and connect via serial using
the COM port number shown in Device Manager.
Congratulations! You are now ready to configure or troubleshoot the
reader.
Technical Support
[email protected]
216-518-9889
www.emxaccesscontrolsensors.com
Documents / Resources
| EMX
RS232 Patriot Reader Serial Port
Kit
[pdf] Instructions
RS232 Patriot Reader Serial Port Kit, RS232, Patriot Reader Serial Port Kit,
Reader Serial Port Kit, Serial Port Kit, Port Kit, Kit
---|---