Optoma WL10C Sensor Box User Manual
- June 24, 2024
- Optoma
Table of Contents
GUANGZHOU SHIYUAN ELECTRONIC CO.,LTD.
Sensor Box User
Manual
Note: All the pictures in this manual are for reference only, subject to our available products.
Safety Warning
Before using and operating this device, please read thoroughly and comply with the following precautions in order to prevent accidents or inaccurate operations.
* Placement
DO NOT charge or use the device in dusty or wet conditions, to prevent
internal circuit failure.
Keep the device away from heat sources such as an electric heater.
Normal operating temperature is 0O-40°C, normal operating humidity is
10%—-90%RH.
* Children Safety
The product and accessories may contain some small—part. Please place them
beyond the reach of children in avoidance of swallowing danger.
* Water Precaution
The product is not waterproof, please keep it dry.
* Maintenance
When the equipment is damaged, please do not disassemble it for repair
without permission, please call customer service to report for repair.
Please contact professional service personnel for maintenance services.
DO NOT insert any sharp or pointed object into the device.
Prevent the device from falls and collisions with other objects, which may
cause damages.
Statement
- Intellectual property right statement: The hardware design and software of this product are covered by the patents. Anyone who reproduces this product or the content of the instruction without the authorization of the Company shall assume legal liabilities.
- This manual is for reference only, and the actual function of the final product is subject to the actual function of the product received by the customer.
- The picture is for reference only, please refer to the actual product. The company reserves the right to improve and change the appearance and design of the product without notice.
Note: The CO2 data of this equipment is calculated by measuring TVOC simulation instead of direct measurement.
Installation Procedure
Warning: Please make sure the power cord of the Interactive Intelligent Panel is disconnected before installation.
-
Installation without Bracket
1. Position the Sensor Box to the bottom
of the Interactive Intelligent Panel in the direction of the arrow.
2. Lock the Sensor Box to the bottom of
the Interactive Intelligent Panel with screws.
3. Use a USB cable to connect the Sensor
Box to the USB interface of the Interactive Intelligent Panel.
4. Complete assembly. -
Installation with Bracket
1. Remove the two screws on the lower
left corner of the Interactive Intelligent Panel.
2. Align the through hole of the bracket
with the lower left corner of the Interactive Intelligent Panel, and fix it
with the cross—slot screw in the accessory package.
3. Hand-tighten the screws to secure
the Sensor Box module to the bracket.
4. Complete assembly.
FCC statement
Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>