Pariplus WG2401 Fire Pit Wind Guard Installation Guide
- June 22, 2024
- Pariplus
Table of Contents
Wind Guard Installation Instructions
(For Model:WG2401,WG2402,WG2403,WG2404,WG2405,WG2406)
Items included
- 4 Glass panels
- 4 Top Brackets with set screws
- 4 Bottom Brackets with set screws and SUS304 plates and footpads
Tools needed
- Phillips screwdriver or other similar screwdriver
Instructions for Wind Guard
-
Carefully remove the panels from packaging and inspect for any damage such as chips or cracks. Place glass panels upside down on a soft flat surface to prevent any damage.
-
Loosen set screws in one of bottom bracket and slide two glass panels into brackets.
Ensure silicone pad is in place on tip of set screws and tighten a little. Go on for the other three bottom brackets in the same way. -
Flip the sub-assembly down and install the Top brackets in the same way, then tighten all the screws when finished all the assembly.
-
Flip fully assembled wind guard over and place on the fire pit and centralize around burner.
Warnings
- Hot glass may cause burns.
- Do not touch glass until cooled.
- Never allow children to touch the glass.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>