blinds2go Blackout Nutmeg Roller Blind Installation Guide
- June 22, 2024
- blinds2go
Table of Contents
Installation Guide
Roller Blinds
Fitting the brackets
Standard finish
The brackets offer three methods of installation:
Top Tip
Top-fixing or face-fixing are recommended for most installations, whereas side-fixing is only recommended if the width you gave us was taken right at the top of the recess.
Cassette finish
The brackets offer two methods of installation:
For cassette finish, note that the position of the outermost brackets should be at least 5cm away from the ends of the rail, with any other brackets evenly distributed across the width.
Fitting the blind
Standard finish
Locate the pin-end (the opposite end to the controls) of the blind into the central hole in the corresponding bracket. Lift the control end of the blind and slot the rectangular ‘lugs’ into the corresponding slots on the bracket.
Cassette finish
To fit the cassette into the bracket, hold the cassette at an angle and locate the central ‘lip’ along the top of the cassette, onto the front ‘hook of the bracket.
Now raise the back of the cassette up and push up firmly into the brackets until you hear them ‘snap’ into place.
For SmartView Roller Blinds
Once your blind is installed we recommend plugging in the motor to allow it to fully charge before use. Plug the charging cable (included) into the motor charging port and allow to charge until the LED on the charger plug turns green.
On the front of the swing tag that comes with your blind, you’ll find a handy QR code you can scan with your phone. Scan this to download the SmartView app – you’ll be setting up your blinds in moments!
Additional Information
Control location (not applicable for cassette finish)
We will have positioned the controls where you requested during the ordering process. However if you decide to swap the side that they are on, direction of the roll or need to trim the blind further, the controls can be removed by simply unplugging them from the tube. This should be done prior to fixing the brackets.
Recycle your electrical and electronic devices free at your local recycling centre. To find your nearest centre, visit the Recycle More website and type in your postcode.
Blinds 2go Ltd is part of the DTS scheme.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>