LPI Terry Cloth Sweat Towel Seat Cover Instruction Manual
- June 16, 2024
- LPI
Table of Contents
LPI Terry Cloth Sweat Towel Seat Cover
TOWEL SEAT PROTECTOR INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION
Read entire installation instructions before starting. Refer to the compatibility chart on the right to ensure your seat is compatible with this seat cover. Be sure to wear safety glasses during installation to avoid any injury possibility. Always make sure your vehicle is off and in park before starting the installation.
WARNING
Before use, ensure the seat cover does not obstruct the function of the seat
belts. Exercise caution when installing to avoid possible elastic snap back.
BE SURE TO WEAR SAFETY GLASSES DURING INSTALLATION. The potential for snap
back could result in serious personal injury. Always be sure vehicle is off
and in park before any installation.
WASHING INSTRUCTIONS
- Remove elastic straps before washing
- Wash in cold water, gentle cycle with mild detergent
- Do not use Laundry Dryer; Hang dry only!
COMPATIBILITY CHART
Please review this chart to determine if this cover will fit your seat before
starting the installation.
INSTALLATION INSTRUCTIONS
Unpack
- Unroll towel seat protector
- Disconnect one side of each elastic mounting straps (3 straps)
Step 1
- Place seat protector on to the seat and over the headrest.
- Align seat protector to desired fit
Step 2
- Connect the (2) rear elastic mounting straps around the back of the seat
- Connect the bottom front elastic mounting strap around the front of the seat
Step 3
- Locate slide adjuster clip on the mounting strap
- Slide adjuster left or right to create a snug fit, do not over tighten
- Repeat for remaining 2 straps
Removal I Storage
- Carefully disconnect each elastic strap and remove protector from seat
- Connect elastic straps back to protector (for storage)
- Fold protector length wise in to 3 sections (about 9″ wide)
- Roll the seat protector starting from the headrest side, use elastic band to secure the rolled protector
