Skytech Fireplace Remote User Manual
- June 16, 2024
- Skytech
Table of Contents
SKY-4001
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
SKYTECH’S remote control system was developed to provide a safe, reliable and
user-friendly remote control system for gas heating appliances. Its battery
operation allows the system to operate independently of household current. The
system operates on radio frequencies with non- directional signals. The
SYSTEM’s operating range is approximately 20 feet. The system operates on one
of 255 security codes programmed at the factory
COMPONENTS
WARNING
THE SKYTECH SKY-4001 MUST BE INSTALLED EXACTLY AS OUTLINED IN THESE
INSTRUCTIONS. FOLLOW INSTRUCTIONS CAREFULLY DURING INSTALLATION. ANY
MODIFICATION OF THE SKYTECH SKY -4001 OR ANY OF ITS COMPONENTS WILL VOID THE
WARRANTY AND MAY POSE A FIRE HAZARD.
TRANSMITTER
TRANSMITTER
The transmitter operates on a 3v battery (included) made specifically for
remote controls and electronic lighters. Before using the transmitter, remove
the insulation tab
protecting one end of the battery in the battery compartment.
The transmitter has ON and OFF functions that are activated by pressing either button on the face of the transmitter. When a button on the transmitter is pressed, a signal light on the transmitter illuminates briefly to verify that a signal has been sent. Upon initial use, there may be a delay of five seconds before the remote receiver will respond to the transmitter. This is part of the system’s design. If the signal light does not illuminate, check the position of the transmitter’s battery
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
FCC Caution: Any changes or modifications not expressly approved by the
party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Important Note:
FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. To maintain compliance with FCC RF exposure
compliance requirements, please avoid direct contact to the transmitting
antenna during transmitting.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Questions about your Skytech Fireplace Remote User Manual? Post in the comments!
.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>