XUANZHI M3-RC 4WD Desert Off-Road Truck RC Car Instruction Manual
- June 14, 2024
- XUANZHI
Table of Contents
XUANZHI M3-RC 4WD Desert Off-Road Truck RC Car
Instructions for Use
Power on method for robot/remote control
- Robot: Press and hold the power button for 0.5 seconds until the base lights up.
- Remote control: Press and hold the power button for 0.5 seconds until the remote control lights up.
Shutdown method for robot/remote control
- Robot: Press and hold the power button for 0.5 seconds until the base indicator light goes out.
- Remote control: Press and hold the power button for 0.5 seconds until the remote control indicator light turns off.
Robot/remote control enters pairing mode
In the shutdown state, press and hold the power button for 5 seconds until the indicator light flashes alternately red and blue. The robot/remote control will automatically search for nearby devices in alignment and connect them.
- There is no matching sequence requirement for the robot/remote control, and devices that enter the matching mode later will be automatically connected.
Tip: If your combat robot is walking backwards, you can press and hold the up and down buttons on the remote control for 5 seconds to modify the direction of the machine’s movement
Charging operation
Use the standard charging cable to connect the USB Type-C interface to the USB
charger (provided by the user) for charging. During the shutdown charging
process, the indicator light is always red, and when fully charged, the green
light is always on. It takes about 40 minutes for the robot to fully charge,
and about 70 minutes for the remote control to fully charge.
- The charging time is determined through laboratory testing and is for reference only
Light effect description
Technical Specifications
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.