Blackview AIRBUDS30 Wireless Earphone User Guide
- June 11, 2024
- Blackview
Table of Contents
AirBuds 30
USER GUIDE
PRODUCT INTRODUCTION
Connect
- Open the lid(Earbuds auto power on).
- After open the phone Bluetooth, Click the [AirBuds 30] to Pairing.
- When the [AirBuds 30] is in the charging case, keep the cover open.
- Then press and hold the Clear key on the bottom of the charging case for about 3 seconds, or until the status indicator light of the charging case flashes green.
- After the pop-up appears on your phone, press “Connect”.
Displays “Device connected” when connection is successful.
Reset
- Delete the pairing data on your phone for the [AirBuds 30].
- Put the earphones back into the charging case and open the cover.
- Press and hold the Clear key on the bottom of the charging case for about 10 seconds, or until the status indicator light of the charging case flashes orange.
- Close the cover to start charging the earphones and wait 20 seconds.
- Open the cover and take out the earphones.
Operation
X 1: Click Once
x 2: Click 2 Times
x 3: Click 3 Times
2 s: Press and hold for 2 seconds
Follow Blackview communtiy, a place where you can share and discuss with Blackview user keep posted with most up-to-day news
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>