Angry Audio Chameleon C4 Livestream Audio Processor User Guide
- June 9, 2024
- Angry Audio
Table of Contents
Angry Audio Chameleon C4 Livestream Audio Processor
C4 Livestream Audio Processing Gadget
Preliminary User Guide
Thanks for purchasing the C4 Livestream Audio Processing Gadget. We are
grateful! The user guide is in the queue and should be published in a few
months. Meantime, here are some operating notes to help you enjoy your new
gadget.
For safety and mounting information, please see the Failsafe Gadget user
guide:
https://angryaudio.com/wp-
content/uploads/2020/08/AA_FailsafeGadgetUserGuide_2008271.pdf
The C4 has an internal power supply, configured at the factory for either 115V
or 230V. The captive power cable is fitted with the appropriate plug for the
intended region. Do not attempt to modify the plug or the power supply. If
your Gadget does not have the proper plug/voltage for your region, contact the
factory to arrange a return/replacement. C4 is equipped with both analog and
digital audio inputs and outputs. Best performance will be achieved using the
digital input and output (AES/EBU) on StudioHub+ RJ45 connectors. To select
the DIGITAL IN as the audio source, flip DIPswitch B to the up position.
Analog inputs and outputs are presented on both XLR and StudioHub+ RJ45
connectors. A convenient ANALOG THRU is useful for daisy chaining the same
source to multiple devices. The Analog Output on the StudioHub+ RJ45 connector
also provides ±15VDC to certain types of connected devices. It is possible for
example, to feed power and processed audio over a single CAT5 cable from this
output to an Angry Audio Headphone Gizmo. The front panel controls are
straightforward. The headphone amplifier with volume control has both 6.3mm
and 3.5mm jacks. The jacks are mutually exclusive. Exercise caution with
headphone volume! It is possible to cause permanent hearing damage with
excessive volume!The graphic below explains the processing functions. 
The C4 Precision Loudness Controller can be engaged or bypassed via the rear
panel DIPswitch. Place DIPswitch A in the up position to engage the Loudness
Controller. Disengage by placing DIPswitch A in the down position. 
That’s it. If you have any questions, give us a shout at: answers@angryaudio.com Use your new gadget in good health! Your friends @ Angry Audio
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>