Shenzhen Finemold Technologies FW068 3-In-1 Wireless Charger User Manual
- June 5, 2024
- Shenzhen Finemold Technologies
Table of Contents
Shenzhen Finemold Technologies FW068 3-In-1 Wireless Charger
Device Layout
Product Parameter
- Product name 3in 1 wireless change
- Material quality ABS + Rubber
- Dimensions 247•74 5• 7 5 mm
- Interface USO – Type C
- Input 9V/2A, 12V/2A
- Mobile phone output: SW/7 SW/1 OW/1 SW, Watch output: 2. SW
- Airpods: 3W
- Compatibility: Support mobile phones, Airpods, and, Watch that comply with the Qi standard
Steps for use
The device is connected to the power supply through the charging cable, and then it can be powered on When charging the mobile phone, place the mobile phone flat in the mobile phone charging area to start charging the mobile phone After fully charged, simply take off the phone, during the charging process, if you need to terminate the charging, take it directly When charging the Apple Watch, place the iWatch flat in the charging area to start charging the watch After fully charged, directly remove the Watch; During the charging process, if you need to terminate the charging, remove the Watch directly When charging the Airpods, place the Airpods flat in the charging area to start charging After fully charged, simply remove the Airpods; During the charging process if you need to terminate the charging, remove it directly
Packaging Accessories
- 3,n 1 wireless chager• 1
- USO-Type C charging cable• 1
- Manual• 1
- Pack ng box• 1
- USO Power Adapter• 1
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receive is connected
- Consult the dealer or an experienced adiofTV technician for help
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>