Fingerprint all-in-one 2.0 Instruction Manual

: June 8, 2024
: Fingerprint

Table of Contents

Read User Manual Online (PDF format)
Download This Manual (PDF format)

Fingerprint all-in-one instructions 2.0
I. Parameters
Size: 868626mm
Screen: black-white screen
Fingerprint identification time: <1.5S
False reject rate: < 0.01%
False accept rate: < 0.0001%
Fingerprint count: 500
Card count: 500 (non-standard)
Code count: 2
Door controlled: 1
Pass mode: fingerprint/card/code, fingerprint & card, fingerprint & code
Linking mode: Offline
II.Operations
TIPs:

The “FP” in the article is short for fingerprint.
The “Bell” in the article means the icon of Bell
Long press on the Bell icon for 3 seconds and enter a six-digit code (default: 888888) to enter the menu.
Disconnect the power supply, long-press the reset button, and switch on the power for 3 seconds then reset the menu code.
Each user number supports three fingerprints and one card.
The pass mode integrating FP and code uses randomly allocated common codes.
Combination password must first press the fingerprint and then code or card plus
Press “Bell” to confirm.
Press “*” to back or cancel.

Menu operations:

Select a number to enter the corresponding menu.
1. User Add
① FP Add
Enter the user number.
If the user number has existed, switch to backup registration.
Press “Bell” to confirm .
Press on the fingerprint reader with the same finger for successive three times.
The registration will end upon a success prompt.
Continue to the adding or backup as prompted on the screen.
② Card Add
Enter the user number.
Press “Bell” to confirm and then punch the card.
The registration will end upon a success prompt.
If the card has already exists, replace it or exit as prompted..
2. Common code
There should be two common code at most.
Enter “1”, press “Bell” to confirm, enter a six-digit common code
and press “Bell” again to confirm.
There will be a prompt of successful saving.
The same operation to register ‘2’
3. Opening Delay
Enter the delay time (maximum: 255s) and press “Bell” to confirm.
4. Time Set
Enter the Specific dateas prompted, press “Bell” to confirm and go to the next line,
Press“*” to return and save.
5. Pass mode
① FP/Card/Code
② FP&Card
③ FP& Code
Enter the corresponding digit and save it.
6. Menu Code
Enter a six-digit code and press “Bell” to confirm.
There will be a prompt of successful saving.
7. User delete
① Number Delete
Enter the user number and press “Bell” to confirm
② ALL Delete
Press “Bell” for four times to confirm.
8. Initialize
Press “Bell” four times to confirm the operation
9.Language
Press“Bell”to confirm to Chinese.
III. Wiring (Installation standards according to Standard for mounting of type 86 base)