DURACELL High Power Inverter 1200/3000 User Guide
- June 8, 2024
- Duracell
Table of Contents
DURACELL High Power Inverter 1200/3000 User Guide
Features
- AC outlets (3 total)
- USB port
- Inverter On / Off switch
- Power/Fault LED lights
- Positive DC input
- Negative DC input
- Cooling vent – IMPORTANT – DO NOT COVER
- Ground connection
- AC output terminal
- AC outlets (3 total)
- AC outlet individual On / Off + circut breaker
- LED digital display
- Digital display select (Watts / Volts)
- Remote port
- Inverter On/Off switch
- Power/Fault LED lights
- Positive DC input
- Negative DC input
- 3 Cooling vents – IMPORTANT – DO NOT COVER
- Ground connection
- Remote On / Off switch
Getting Started
SAVE THESE INSTRUCTIONS — this manual contains safety and operating instructions for the inverter. Misusing or incorrectly connecting the inverter may damage the equipment or create hazardous conditions for users. Read the following safety instructions and pay special attention to all Caution and Warning statements in the guide.
Warnings identify conditions that may result in personal injury or loss of life.
Cautions identify conditions or practices that may damage the unit or other equipment.
IMPORTANT
Consult an electrician. Installations must meet local and national wiring codes.
Installation
Wire Selection
Use the thickest gauge and shortest length allowed by your configuration and budget. As a rule of thumb no more than 2% loss should be allowed. The chart below lists minimum specifications, please consult a wire gauge chart for longer installations.
Failure to follow these safety guidelines may cause personal injury and/or damage to the inverter. It may also void your product warranty.
Maximum cable length (ft.) [2%voltage drop]
IMPORTANT
All connections must be clean and tight for optimal performance. Loose connections will result in higher resistance loss of power and increased heating. Do not cover or obstruct ventilation openings.
Install in a ventilated area, leave at least 6 inches of space in front and behind the inverter for ventilation and at least2 inches around the top and sides for the cooling fins to dissipate heat.
Connecting the power cable to the inverter terminal must be in this order
Grounding
The ground connection can be connected to earth or chassis ground depending on the installation:
- Land: Connect to earth ground
- Vehicle: Connect to vehicle chassis of the vehicle. If power equipment is used outside the vehicle an earth-stake should be used.
WARNING
Loose connectors result in excessive voltage drop and may cause overheated wires and melted insulation, which can lead to electrical fires. Reverse polarity connections (positive to negative) will blow internal fuses in the inverter and may permanently damage the inverter.
Permanent Installation
See diagram below. Install a UL-listed fuse in-line with the red input cable, as close to the battery as possible. Ensure tight connections.
Fuse size
DRINV1200 : ANL-200
DRINV3000: ANL-400
-
Connect the negative (black) terminal of inverter to the negative battery post.
-
Connect the positive (red) terminal of inverter to the positive battery post.
-
Connect the ground terminal according to the GROUNDING section above.
Direct Connect AC Terminal (DRINV3000 model only)
IMPORTANT
AC extension wire and socket are not included with this inverter. Each wire should be no thicker than 10AWG.
- Remove the cover to access the terminals.
- Expose no more than 1/2″ of conductor from each wire and secure the rest through the strain relief.
- AC wire colors:
- Line/Hot — Black or Brown
- Neutral — White or Blue
- Ground — Green or Green/Yellow
Using The Inverter
IMPORTANT
The inverter draws current in the ON position, switch it OFF to prevent it from drawing power from the batteries.See “no-load power draw” section in the specification table.
Connecting your devices/appliances
- Ensure that all connections are secure and DC power is available.
- Connect AC devices.
- Connect USB devices (1200 Watt InverterOnly)
- Turn the inverter On/Off switch ON.
NOTE: Turn the inverter On/Off switch to OFF when done using the inverter to avoid discharging your battery.
IMPORTANT
Your inverter is able to operate several devices at once, up to its maximum combined load. The1200Watt inverter can power a combined load of up to 1200 Watts of continuous power. The 3000 Watt can power a combined load of up to 3000 Watts of continuous power. If the total power draw of the connected devices, tools and/or appliances exceeds this maximum, the inverter will automatically shut down to avoid dangerous overload. The chart below shows an approximation of typical wattages for popular electrical items. Please consult the manual(s) of your device(s) to determine the exact wattage of your particular model.
LED display (3000 Watt inverter only)
Use the digital display select switch to show AC output power in Watts or battery voltage in Volts.
Remote On/Off switch (3000 Watt Inverter only)
In order to use the remote, the inverter On/Off switch must be in the OFF position. The inverter can then be turned ON or OFF with the remote switch.
Safety
Under Voltage
At 10.5±0.3V input an alarm sounds, at 10.0V the inverter shuts down and the FAULT LED turns on. This protects the battery from over discharge.
Over Voltage
If the input voltage is > 15V, an alarm sounds, the inverter shuts down to protect itself and the FAULT LED will illuminate.
Over Load
When power output exceeds the rated continuous power for extended periods of time or the surge power for more than 20 seconds the inverter will shut down. After the excessive load is removed the inverter can be restored by turning it on and off.
Over Temperature
An alarm will sound and the FAULT LED will illuminate if the inverter overheats and will shut down if it does not cool down. Poor ventilation, over load or high room temperature can cause an overheating condition. The cooling fan is temperature controlled and turns on to prevent overheating during normal operation.
Short Circuit
When an output short circuit occurs, the inverter will beep, the FAULT LED will turn on and the inverter will shut down.
Specification
Troubleshooting
Recycling
Battery-Biz is committed to environmental responsibility and recommends that electronic devices be disposed of properly. Please contact your local city offices for information on recycling and disposal programs for e-waste.
For instructions on how to recycle this product visit http://www.call2recycle.org.
Contacting Customer Support
If you experience any problems or have any questions regarding your DURACELL® inverter, free technical support is available. Prior to calling, please review the technical support tips below.
Call from a phone where you have access to your mobile device
Be prepared to provide the following information:
- Name, address and telephone number
- Name of the DURACELL® product
- Make and model of your device
- Symptoms of the problem(s) and what led to them
Technical Support is available by telephone:
U.S. and Canada 800-300-1857
Outside of the US/Canada: 805-437-7765
Written inquires should be directed to:
Battery-Biz Inc.
DURACELL® Product Inquiry
1380 Flynn Road, Camarillo, CA 93012, USA
WARNING
This Product contains chemical(s) known to the State of California to cause cancer, birth defects, or other reproductive harm.
DURACELL High Power Inverter 1200/3000 User Guide – Download
[optimized]
DURACELL High Power Inverter 1200/3000 User Guide –
Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>