Bissell 2142 Series Digipro Robotic Vacuum Quick Start Guide
- June 8, 2024
- Bissell
Table of Contents
Bissell 2142 Series Digipro Robotic Vacuum
Assembly Instructions
- First, turn the power switch to the OFF position. Press on the two circles of the battery cover and slide the cover towards you and insert the battery
- Install the battery in the compartment, ensuring the +/- terminals of the battery match the +/- indicators in the battery compartment.
Getting Ready to Clean
-
Install the edge cleaning brush by pushing directly in to the holder.
-
Turn ON the power switch and charge the battery directly from the power cord for 4-5 hours prior to first operation.
WARNING: Refer to the enclosed user guide for complete instructions and important safety notices.
PARTS INCLUDED
1| BISSELL DigiPro® Robotic Vacuum|
---|---|---
2| Rechargeable Li-Ion Battery|
3| Dust Bin| 
4| Edge Cleaning Brushes| 
5| Programmable Docking Staton|
6| Power Adapter| 
7| Filter (Located inside Dust Bin)|
NOTE: Not all accessories come with every model. Be sure to check the carton for additional tools.
Setting up the Docking Station
Make sure the docking station is installed correctly with at least 40 inches
to one side, 12 inches to the opposing side and no obstructions in front of
the docking station. After the initial charge is complete, plug the wall
adaptor directly into the docking station.
To test the auto-charge feature of the dock, turn the power switch on the
vacuum ON, and select “00“ with the center button. The vacuum should back into
the dock for recharging if the appropriate spacing was provided for the
docking station.
For detailed instructions on how to setup the scheduled cleaning feature of the docking station, see above in the user guide.
Starting the Initial Clean
Ensure the floors are clear from obstructions such as blankets, clothing,
cords and toys.
To begin the initial clean, set the robot on the floor and ensure the power
switch is ON. Wait for the center button on the display to turn green, and
then press the button once. (Display will light up and 99 will show on the
screen.)
In this manual setting, the robot will clean until the battery requires a
charge and will automatically return to the docking station.
For additional manual cleaning modes and functions of The led display, please check above in the user guide.
LED E Alerts (Power LED Flashes Red)
| Display on screen | Possible cause | Solution |
|---|---|---|
| The wheel is stuck | Remove vacuum from obstacles, and restart the power |
switch.
| The top cover or dust bin is not installed properly| install the top cover
and dust bin properly. The unit will detect the error and fix automatically.
If the unit does not fix automatically, turn the unit off and back on
| The bumper is stuck.| Remove vacuum from obstacles. The unit will detect the
error and fix automatically.
| The unit was lifted up from the floor| Put vacuum back on the floor.
| The color of the floor is too dark.| Remove robot from the flooring. Do not
operate robot on flooring where error occurred.
| The battery is not installed properly. Charging error. (Power switch is
off)| To install the battery properly, please refer to page 5 for battery
installation, and turn on the power switch after installation is complete.
Display on screen| Indication
| Battery Low: Battery needs to be charged. (Power LED turns Red).
Bissell 2142 Series Digipro Robotic Vacuum Quick Start Guide – Download
[optimized]
Bissell 2142 Series Digipro Robotic Vacuum Quick Start Guide –
Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>