Electrolux EL2050 to EL2059 Sereis ergorapido User Manual

Electrolux EL2050 to EL2059 Series ergorapido User Manual

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.

WARNING

To reduce the risk of fire, electric shock, or injury:

• Do not use outdoors or on wet surfaces.
• Do not operate the vacuum cleaner or charger if it has been damaged in any way. If cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
• To avoid excessive heat and damage to the unit or batteries, do not operate the vacuum cleaner while charging.
• Do not allow to be used as a toy. Close attention is necessary when used by or near children.
• Use only as described in this manual.
• Use only the charger provided to recharge: SSA-135045US
• Do not pull or carry by the cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Keep cord away from heated surfaces.
• Do not use extension cords or outlets with inadequate current carrying capacity.
• Do not unplug by pulling on cord. To unplug, grasp the charger, not the cord.
• Do not handle charger, including charger plug, and charger terminals with wet hands.
• DO NOT MUTILATE OR INCINERATE BATTERIES AS THEY WILL EXPLODE AT HIGH TEMPERATURES.
• Leaks from battery cells can occur under extreme usage or temperature conditions. If the liquid gets on skin, wash quickly with water. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes. Seek medical attention.
• While there is no shock hazard from electrical terminals located on the vacuum, a burn could result from metal objects being inserted into the terminal areas. Vacuum cleaner terminals should always be kept free of objects.
• This vacuum cleaner creates suction and has a revolving brushroll. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
• Do not use without a filter in place. When servicing the unit, never put fingers or other objects into the fan chamber in case the unit would accidentally be turned on.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or combustible liquids such as gasoline, or use on areas where they may be present.
• Locate charger indoors in a cool, dry area, not exposed to weather to avoid electrical shock and/or cleaner damage.
• Keep your work area well lighted.
• Unplug electrical appliances before vacuuming them.
• Use only manufacturer’s recommended attachments.
• Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce airflow.
• Do not charge the vacuum cleaner outdoors.
• Do not incinerate the vacuum cleaner even if it is severely damaged. The batteries can explode in a fire.
• WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or reproductive harm. WASH HANDS AFTER HANDLING

SAVE THESE INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

Consumer Information

Electrolux declines all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. All plastic parts are marked for recycling purposes. For details, see our web site: www.electrolux.com If you are interested in purchasing additional accessories for your Electrolux Ergorapido, please visit our website at www.electroluxappliances.com (USA), www.electrolux.ca (Canada) or call 1.800.896.9756.

COMPONENTS AND ACCESSORIES

1. On/off button, power setting
2. Power Setting High/Low button
3. On/off button, hand unit
4. Handle
5. Locking screw
6. Release button, hand unit
7. Charging adapter
8. Fine filter (inner filter)
9. Pre filter (outer filter)
10. Release button, dust container
11. Brush/Crevice tool
12. Brushroll release buttons
13. Brush roll
14. Charging Light Indicator

UNPACK AND CHECK CARTON CONTENTS

Check all accessories against the “Components and Accessories” list

CAUTION: Do not leave cleaner turned on and unattended. Store cleaner in a cool, dry area.

Assembly

1. Remove screw from main body. Fit the handle carefully inserting it into the lower main body. Make sure that the cable does not jam.

2. Secure the handle by tightening the locking screw supplied. Use a screwdriver or a coin.

Charging

Before First use: Charge up to 24 hours. Leave Ergorapido on charge when not in use. Warm adaptor is normal.

3. When fully discharged , to regain full battery capacity, position the charging adapter away from heat sources, direct sunlight or wet places. Insert the adapter into the outlet and connect it to the Ergorapido.

• Approximately 4 hours’ charging is required

4. The charging indicator light , will come on when the machine begins to charge once it is correctly plugged in.

5. If light is lit : Machine is charging.

6. If light is blinking :
Machine is fully charged and in standby mode, indicated with one blink per minute.

Start/Stop

7. Start the Ergorapido by pushing the top button.
The bottom button can be used to switch between High Speed (for maximum cleaning power) and Normal Speed (for longer use).

Vacuuming floors and carpets

8. Avoid scratching hard wood floors areas by checking that nozzle wheels and brushroll are clean.

Using the Hand Vac

9. Remove the hand unit by pressing the release buttons.
The crevice nozzle and small brush are stored together as one piece. Push on middle tab to separate.

10. Attach the crevice nozzle to facilitate cleaning of areas difficult to reach, or attach the brush for dusting. Start/stop the hand unit by pushing the start button.
CAUTION: For service not described in this manual, take to Electrolux Authorized Service Center for repair. Ergorapido’s dust container must be emptied regularly and the dust container and the filters need to be cleaned to maintain a high suction power
Never wash dust containers or filters in a dishwasher.

Emptying and cleaning

11. Emptying of the dust container. Remove the filters, empty the contents into a dust container. Return filter and click dust container back into place.

12. Quick cleaning of the fine filter. (Recommended every cleaning). Release the dust container, pull/release spring 5-6 times to dislodge dust.

13. Cleaning of dust container and filters. (Recommended every 5th cleaning). Release dust container, take out both filters by pressing release buttons.

14. Separate both filters. Dust container and filters can be shaken clean or rinsed in warm water ( never in dishwasher ). All parts must be dry before reassembled in reverse order.

Cleaning the hose and wheels

15. Loosen the hose catch and pull the hose from the attachment. Remove any debris. Put the hose back, lock using the catch.

16. Remove objects that may have become jammed in the wheel shafts.

Cleaning the brushroll

17. If the brushroll becomes blocked or jammed for any reason. The brushroll may need to be cleaned. First turn Ergorapido® off. Push the brushroll release button. The hatch cover will come slightly free and the brushroll can now be removed.

18. Lift out the brushroll and clean it. Carefully use a pair of scissors or a sharp knife to remove any items such as threads that may have become entangled. Replace the brushroll and make sure that it fits into its guiding tracks, and that it can spin freely. Replace the hatch cover.

Water has entered the vacuum cleaner

It will be necessary to replace the motor at an authorized Electrolux service center. Damage to the motor caused by the penetration of water is not covered by the warranty.

If you can’t find accessories for your Electrolux vacuum cleaner, please visit our website at www.electroluxappliances.com (USA), www.electrolux.ca (Canada) or call 1-800-896-9756

Removing batteries

CAUTION: Only remove batteries if product is to be scrapped. Improper handling of the batteries may be hazardous. Batteries must be removed from the appliance before it is scrapped or recycled. Never dispose used batteries with household waste. Batteries should always be completely discharged before removal. Ergorapido must be disconnected from the power source when removing the batteries.

1. Undo the screws. Carefully lift the hood.
2. Cut the connecting cables, remove the batteries, put tape over the visible metal areas. Place batteries in suitable packaging.

To locate nearest recycling center please call 1.877.273.2925 or visitwww.call2recycle.org

Troubleshooting

The brushroll stops spinning

1. Turn off power.
2. Remove any obstructing objects from the brushroll.
3. Allow 5 minutes for motor to cool before powering on.

Unit is too hot

1. Clean filters, brush roll, hose and put on charge.

Motor is overloaded, causing the vacuum to turn off

1. Clear obstruction from brushroll and turn unit on.

If Ergorapido turns itself off while in use or will not stay on

1. Unit may have run out of charge. Make sure you are charging your unit for the correct amount of time, and that the outlet you are using is receiving power.
2. Unit may be too hot. Clean filters, brushroll, hose, and put on charge.
3. Motor may be overloaded. Clear obstruction from brushroll and turn unit on.
4. Check if there are large carpet fibers, heavy threads, or wires in the brushroll – the self-cleaning brush feature will not be able to remove these obstructions.

Electrolux EL2050 to EL2059 Sereis ergorapido User Manual – Download [optimized]
Electrolux EL2050 to EL2059 Sereis ergorapido User Manual – Download

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>