VOLLRATH 38736W Cafeteria Breath Guard Instruction Manual

June 8, 2024
VOLLRATH

VOLLRATH 38736W Cafeteria Breath Guard

Specifications

  • Product Name: Cafeteria Breath Guard
  • Models: One Piece and Three Piece
  • Manufacturer: The Vollrath Company, L.L.C.
  • Item Number: 2350030-01 Rev 04/12

FAQ

  • Q: What should I do if I encounter cracked plastic during installation?
    • A: If you encounter cracked plastic during installation, stop tightening immediately to prevent further damage. Contact customer service for assistance on how to proceed.
  • Q: Can I disassemble the breath guard for cleaning?
    • A: Yes, you can disassemble the breath guard for cleaning purposes. Follow the installation steps in reverse to disassemble and clean each component separately.

These instructions cover the installation of the one pice Cafeteria Breath Guard and the three piece Cafeteria Breath Guard.

Installation Instructions

One Piece Breath Guard Installation

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:

NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

  1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
  2. Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
  3. Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
  4. Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.

Three Piece Breath Guard Installation

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:

NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

  1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
  2. Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
  3. Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
  4. Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
  5. Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
  6. Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.

Contacts

The Vollrath Company, L.L.C.

  • 1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A.
  • Main Tel: 800.628.0830
  • Service Tel: 800.628.0832
  • FAX: 800.752.5620

Vollrath of Canada, Co.

  • Tel: 800.695.8560
  • FAX: 800.752.5620

www.vollrathco.com

© 2010 The Vollrath Company, L.L.C.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

VOLLRATH User Manuals

Related Manuals