velleman WB043 WALL SUPPORT User Manual
- June 3, 2024
- Velleman
Table of Contents
velleman WB043 WALL SUPPORT User Manual
Component Checklist
-
Wall mount (x1) A
-
Safety bar (x1) B
-
Left adapter bracket (x1) C
-
Right adapter bracket (x1) D
-
antiskid block
-
decorative cover
-
ST 2.9×6.5
(x4) G
Package M
Mounting hardware (not incl.)
Install decorative covers
Wood stud wall mounting
Solid brick and concrete mounting
Installing adapter brackets
For flat back screens
For Recessed Back Screen or to Access A/V Inputs
Hanging the TV onto the wall plate
Installing the antiskid blocks
Inserting the safety bar
Adjustment
Safety Instructions
- Do not begin the installation until you have read and understood the instructions and warnings contained in this installation sheet.
- If you have any questions regarding any of the instructions or warnings, please contact your local distributor.
- This mounting bracket was designed to be installed and utilized only as specified in this manual.
- Improper installation of this product may cause damage or serious injury.
- This product should only be installed by someone of good mechanical ability, with basic building experiences and fully understanding of this manual.
- Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
- Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
- Tighten screws firmly, but do not overtighten.
- Overtightening can damage the items, greatly reducing their holding power.
- This product is intended for indoor use only.
- Using this product outdoors could lead to product failure and personal injury.
Component Checklist – Important
- Ensure that you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, contact your local distributor for a replacement.
- Mounting hardware not included.
Mounting
Install decorative covers
Attach decorative covers to wall plate using screws, with the gap of the decorative cover downward.
Wood stud wall mounting
- Mark the exact location of the mounting holes.
- Drill pilot holes.
- Screw the wall mount onto the wall.
Warnings
- Make sure that the mounting screws are anchored in the centre of the studs.
- The use of a stud finder is highly recommended.
- Installers are responsible for providing hardware for other types of mounting situations.
- The installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
Solid brick and concrete mounting
- Mark the exact location of the mounting holes.
- Drill pilot holes.
- Screw the wall mount onto the wall.
Warnings
- When installing wall mounts on cinder blocks, verify that the actual concrete thickness is at least 1-3/8″ (35 mm) for using the concrete anchors.
- Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1″ (25 mm) minimum from the side of the block.
- We suggest to use an electric drill on slow setting to drill the hole instead of a hammer drill to avoid breaking out the back of the hole when entering a void or cavity.
- The installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
Installing Adapter Brackets
- For flat back screens:
- For recessed back screen or to access A/V inputs:
Notes
- Choose appropriate screws, washers and spacers (if necessary) according to the type of screen.
- Position the adapter brackets as close as possible to the centre of the display.
- Screw the adapter brackets onto the display.
- Tighten all screws but do not over tighten.
Hanging the TV onto the wall plate
Two qualified persons are required.
Installing the antiskid blocks
- Install both antiskid blocks as close to the adapter brackets as possible.
- Tighten screws on the antiskid blocks using a proper screwdriver to prevent display from moving.
Inserting the safety bar
- Insert the safety bar to secure the rails.
- Use a padlock to prevent TV from being stolen (padlock not included).
Adjustment
Adjust to the desired location or tilt.
Maintenance
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
- Please contact your dealer if you have any questions.
Technical Specifications
TV size | 46″ – 70″ (117-178 cm) |
---|---|
max. load | 40 kg / 88 lb |
TV to wall distance | 77 – 548 mm |
Tilt | -10° to +5° |
swivel | 180° |
level adjustment | -4° to +4° |
VESA mount | 300 x 300 – 400 x 200 – 400 x 400 – 600 x 400 |
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulting from (incorrect) use of
this device.
For more info concerning this product and the latest version of this manual,
please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written
consent of the copyright holder.
Warranty
Velleman® Service and Quality Warranty
Since its foundation in 1972, Velleman® acquired extensive experience in the
electronics world and currently distributes its products in over 85 countries.
All our products fulfil strict quality requirements and legal stipulations in
the EU. In order to ensure the quality, our products regularly go through an
extra quality check, both by an internal quality department and by specialized
external organisations. If, all precautionary measures notwithstanding,
problems should occur, please make appeal to our warranty (see guarantee
conditions).
General Warranty Conditions Concerning Consumer Products (for EU):
- All consumer products are subject to a 24-month warranty on production flaws and defective material as from the original date of purchase.
- Velleman® can decide to replace an article with an equivalent article, or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses are out of proportion.
You will be delivered a replacing article or a refund at the value of 100% of the purchase price in case of a flaw occurred in the first year after the date of purchase and delivery, or a replacing article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery.
Not covered by warranty:
- all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity…), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits;
- consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, nonrechargeable, built-in or replaceable), lamps, rubber parts, drive belts… (unlimited list);
- flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…;
- flaws caused deliberately, negligently or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions;
- damage caused by a commercial, professional or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally);
- damage resulting from an inappropriate packing and shipping of the article;
- all damage caused by modification, repair or alteration performed by a third party without written permission by Velleman®.
- Articles to be repaired must be delivered to your Velleman® dealer, solidly packed (preferably in the original packaging), and be completed with the original receipt of purchase and a clear flaw description.
- Hint: In order to save on cost and time, please reread the manual and check if the flaw is caused by obvious causes prior to presenting the article for repair. Note that returning a non-defective article can also involve handling costs.
- Repairs occurring after warranty expiration are subject to shipping costs.
- The above conditions are without prejudice to all commercial warranties.
The above enumeration is subject to modification according to the article (see article’s manual).
Documents / Resources
|
velleman WB043 WALL
SUPPORT
[pdf] User Manual
WB043 WALL SUPPORT, WB043, WALL SUPPORT, SUPPORT
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>