IKEA TRADFRI User Manual
- June 7, 2024
- Ikea
Table of Contents
Design and Quality
IKEA of Sweden
TRÅDFRI
WIRELESS ON/OFF SWITCH FUNCTIONS
ON – Dim UP
Press to turn your IKEA Home smart product on. Press and hold to dim up.
OFF – Dim DOWN
Press to turn your IKEA Home smart product off. Press and hold to dim down.
Pairing: Add IKEA Home smart products to your system. See instructions below.
ADDING DEVICES TO YOUR WIRELESS ON/OFF SWITCH
When the wireless ON/OFF switches are sold together with an IKEA Home smart
product (in the same package), they are already paired.
To add more products, just repeat the steps below:
Make sure that the main power is turned on.
- Hold the ON/OFF switch close to the IKEA home smart device you want to add (no more than 5 km away).
- Press and hold the pairing button for at least 10 seconds, you can find the pairing button under the rear cover.
- A red light will shine steadily on the ON/ OFF switch. On your IKEA Home smart device, the pairing indicator will begin to dim and flash one time to indicate that it has been successfully paired.
Up to 10 IKEA Home, smart devices can be paired with 1 ON/OFF switch.
Make sure to pair them one at a time. If the IKEA Home smart products are
close to each other, disconnect those that have already
been paired from the main power.
FACTORY RESET YOUR DEVICE
For wireless ON/OFF switch:
Press the pairing button 4 times within 5 seconds.
CHANGING THE BATTERY
When the wireless ON/OFF switches are used regularly and as intended, the
battery will last for approximately 2 years.
When it’s time to replace the battery, a red LED indicator will flash when you
toggle the ON/OFF switch.
Open the rear cover, and replace the battery with a new CR2032 battery.
CAUTION!
Risk of explosion if the battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
IMPORTANT!
— The wireless ON/OFF switch is for indoor use only and can be used in
temperatures ranging from 0ºC to 40 ºC (32ºF to 104ºF).
— Do not leave the wireless ON/OFF switch in direct sunlight or near any heat
source, as it may overheat.
— The range between the wireless ON/OFF switch and the receiver is measured in
the open air. Different building materials and placement of the units can
affect the wireless connectivity range.
CARE INSTRUCTIONS
To clean the wireless ON/OFF switch wipe with a soft dry cloth.
NOTE!
Never use abrasive cleaners or chemical solvents as this can damage the
product.
Save these instructions for future use.
TECHNICAL DATA
Type: E1743 wireless ON/OFF switch Input: 3V, CR2032 Battery
Range: 10 m in open air For indoor use only
Operating frequency: 2405-2480Mhz
Output power: 3 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81, SWEDEN
This device complies with Part 15 of the FCC Rules/Industry Canada licence- exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE INFORMATION
This product is approved as a portable handheld device (not body-worn)This
product includes a static magnet, generating a magnetic field that might
interfere with the normal operation of pacemakers, defibrillators, or other
medical devices.
Maintain a safe distance of separation between your medical device and this
device. Stop using this device and consult your physician or medical device
manufacturer if you believe that it is interfering with your medical device.
License rights and limitations
NO RIGHTS OR LICENSES, EXPRESS NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE
GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A
WIRELESS MESH NETWORK, OR TO USE THIRD-PARTY SERVICES TO ACCESS, MONITOR, OR
CONTROL THESE PRODUCTS IN A WIRELESS MESH NETWORK VIA THE INTERNET OR ANOTHER
EXTERNAL WIDE AREA NETWORK.
For use pursuant to U.S. Patent Nos.:
US 6,914,893
US 7,697,492
US 8,964,708
The
crossed-out wheeled bin symbol indicates that the item should be disposed of
separately from household waste. The item should be handed in for recycling in
accordance with local environmental regulations for waste disposal. By
separating a marked item from household waste, you will help reduce the volume
of waste sent to incinerators or land-fill and minimize any potential negative
impact on human health and the environment. For more information, please
contact your IKEA store.
© Inter IKEA Systems B.V. 2018
AA-2173011-1