RDX Standard Speed Ball Platform Instruction Manual
- June 7, 2024
- RDX
Table of Contents
RDX Standard Speed Ball Platform Instruction Manual
Standard Speed Ball platform
Tools Required
Plastic or Wooden Mallet 10 MM Masonry Drill Bit Philips Screw Driver
Parts List
A – M6 x 30 C/Sunk Screws 4
B – M6 Washers 4 C – M6 Nylock Nuts 4
D – M4 x 30 C/Sunk Screws 4 E – M4 Washers 4
F – M4 Nylock Nuts 4 G – 11/4 End Caps 3
H – M8 x 60 Coach Screws 6 I – 10 x 50 Nylon Plugs 6 J – M8 x 50 Cup Square
Bolts 2 R – M8 Hand Wheels 2
Important Notice
❖ The bracket must be fixed to a solid surface and not to a cavity or plaster
board wall.
❖ Use Mallet to Insert G.
❖ Drill Holes 65MM deep to insert I.
❖Check all fixing before use
DISCLAIMER
MAKE SURE TO ASSEMBLE THIS PRODUCT ACCORDING TO THE INSTRUCTIONS. FAILURE TO DO SO MIGHT TRANSLATE INTO HARMFUL CONSEQUENCES. MAKE SURE THAT THE WEIGHT OF THE EQUIPMENT DOESN’T EXCEED THE WEIGH!. CAPACITY OF THIS PRODUCT. IF YOU LACK THE NECESSARY EXPERTISE TO ATTACH THIS PRODUCT TO THE WALL STRUCTURE THAT YOU’RE USING, CONTACT A CONSTRUCTION PROFESSIONAL TO INS IALL THE WALL MOUN1 OR TO PROVIDE SPECIFIC MOUNTING INSTRUCTIONS FOR YOUR WALL STRUCTURE. BRACKET MUST BE FIXED TO A SOLID SURFACE NOT TO A CAVITY OR PLASTER BOARD WALL.