RDX Standard Wall Bracket Instruction Manual
- June 7, 2024
- RDX
Table of Contents
RDX Standard Wall Bracket
TOOLS REQUIRED
10mm Masonry Drill belt
10mm Spanner or Socket
Plastic/ Wooden Mallet
Parts List
- M8 x 65 Hex Bolt x 3
- M10 x 50 Nylon Plug x 3
- 25 x 25 End Cap x 1
- 22 x 22 End Cap x 2
- 8mm Dee-Shackle x 1
Installation
- Follow the diagram to fix your bracket to either a brick/stone wall.
- Use a mallet to insert C & D.
- Drill hole 65 mm deep to insert B.
- Ensure all bolts are tightened.
Disclaimer
Make sure to assemble this product according to the instructions. Failure to
do so might translate into harmful consequences. Make sure that the weight of
the equipment doesn’t exceed the weight of the capacity of this product. If
you lack of the necessary expertise to attach this product to the wall
structure that you are using . Contact a construction professional to install
the wall mount or to provide specific mounting instructions for your wall
structure. Bracket must be fixed to a solid surface not to a cavity or plaster
board wall.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>